Volkswagen Golf / Golf GTI / Jetta. Manual — part 242
24-222
If the specifications are not
obtained:
- Remove wiper arms and cowl
panel:
Repair Manual, Electrical
Equipment; Repair Group 92
Electrical Wiring Diagrams,
Troubleshooting & Component
Locations
- Connect VAG 1598/31 test box to
control module wiring harness.
Engine Control Module (ECM) -
J220- remains disconnected.
- Check wiring for open/short circuit
from Motronic Engine Control
Module (ECM) -J220- to CCS
operating switch:
- Check DTC memory, repair
malfunctions if necessary and
then erase DTC memory
Page
01-23
.
- Read readiness code
Page 01-
146
. If DTC memory has been
erased or Motronic Engine
Control Module (ECM) -J220- was
disconnected from battery
positive (B+), readiness code
must be generated again
Page
01-149
.
Additional signals, checking
24-223
CAN-bus, checking
Function
The Motronic Engine Control Module (ECM)
-J220- communicates with other CAN-bus
compatible control modules via a CAN-bus.
These CAN-bus-capable components are
connected by a pair of twisted CAN-bus
wires (CAN high and CAN low) and
exchange information (messages).
Information missing from the CAN-bus is
recognized as an error and stored.
The CAN-bus requires a matching resistor
to function fault free. This matching resistor
is located in the Motronic Engine Control
Module (ECM) -J220-.
Additional signals, checking
24-224
Special tools, materials and
equipment
Note:
All functions which could previously
be performed with VAG 1551/1552
can also be performed with the VAS
5051.
VAG 1551 Scan tool (or VAG
1552) with VAG 1551/3 adapter
cable
VAG 1526 or Fluke 83 Hand
multimeter or VAG 1715
multimeter
VAG 1594 Adapter set
VAG 1598/31 test box
Electrical Wiring Diagrams
Additional signals, checking
24-225
Test requirements
The CAN-bus On Board Diagnostic (OBD)
has detected a Diagnostic Trouble Code
(DTC).
Test sequence
- Remove wiper arms and cowl panel:
Repair Manual, Electrical Equipment; Repair
Group 92
- Connect VAG 1598/31 test box to Motronic
Engine Control Module (ECM) -J220-. ECM
wiring harness is not connected by this action.
- Check centralized matching resistor in Motronic
Engine Control Module (ECM) -J220-. To do
this, check resistance between test box
Sockets 58 and 60.
Specification: 60 to 72
Additional signals, checking
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст