Volkswagen Golf / Golf GTI / Jetta. Manual — part 501
- Press out drive axle.
Note:
n
When pressing drive axle out ensure sufficient
clearance is available.
- Pull wheel bearing housing with ball joint out from control
arm.
- Remove drive axle from wheel bearing housing and tie up.
The axle shaft must not hang down!
The inner joint will be damaged through overflexing.
- Remove phillips-head screw for brake disc and take out
brake disc.
- Remove cover plate.
- Remove connecting link from control arm.
- Release speed sensor wiring from suspension strut.
Note:
n
Place engine/transmission jack V.A.G1383/A
underneath (danger of accident from falling parts
when removing the wheel hub and wheel bearing).
Pulling out wheel hub
Front suspension, servicing
- Insert thrust bolts - 1 - in wheel bearing housing.
- Install support - 2 - , piston cylinder - 3 - with pull rod and
special nut - 4 - .
- Hold tool securely and pull out wheel hub.
1 - Thrust bolt E-15
2 - Bell E-40
3 - Piston cylinder HKZ-15
4 - Special nut E-8-214 and pull rod
Pulling out wheel bearing
- Remove circlip.
- Install press piece - 1 - with shoulder to bearing, press
sleeve - 2 - with four stepped internal diameters to wheel
bearing housing, piston cylinder - 3 - with pull rod and
special nut - 4 - .
- Operate pump and remove wheel bearing.
1 - Thrust tube E-5
2 - Press sleeve E-65-1
3 - Piston cylinder HKZ-15
Front suspension, servicing
4 - Special nut E-8-214 and pull rod
Pulling off bearing inner race from hub
Pressing in wheel bearing
- Clean hole from wheel bearing housing
- Grease hole completely with Molykote grease.
Molykote grease, G 052 723 A2
Use grease packet from repair kit
- Install wheel bearing - 1 - , press piece - 2 - install with
collar in bearing) and piston cylinder - 3 - with pull rod on
wheel bearing housing.
Front suspension, servicing
- Install thrust piece - 4 - with wide collar toward wheel
bearing housing and special nut - 5 - on inside.
- Press wheel bearing in by operating pump.
- Insert circlip with needle nose pliers.
1 - Wheel bearing
2 - Thrust tube E-13-1
3 - Piston cylinder HKZ-15
4 - Thrust tube E-10
5 - Special nut E-8-214 and pull rod
Pressing in wheel hub
- Install hub - 1 - and piston cylinder - 2 - with pull rod on
wheel bearing.
- Install thrust piece - 3 - with collar toward special nut - 4 -
on inside.
- Press in hub by operating pump.
1 - Wheel hub
2 - Piston cylinder HKZ-15
3 - Thrust tube E-5
4 - Special nut E-8-214 and pull rod
Further installation is in reverse sequence to removal.
III - Front suspension strut, assembly
overview
Front suspension, servicing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст