Volkswagen Golf / Golf GTI / Jetta. Manual — part 138
01-131
If no electrical or wiring concerns are
found:
- Check wire for open circuit
between test box socket 115 and
2-pin connector terminal 2
referring to Electrical Wiring
Diagrams.
Wire resistance: max. 1.5
- Additionally check wire for short
to battery positive and Ground
(GND).
Specification:
- Check wire for open circuit
between 2-pin connector terminal
1 and Motronic Engine Control
Module (ECM) Power Supply
Relay -J271- referring to Electrical
Wiring Diagrams.
Wire resistance: max. 1.5
- Replace Motronic Engine Control
Module (ECM) -J220-
Page 24-
173
.
- Check DTC memory, repair
Diagnostic Trouble Codes (DTCs)
if necessary and then erase DTC
memory
Page 01-23
, DTC
memory, checking and erasing.
- Erase learned values and adapt
Motronic Engine Control Module
(ECM) -J220- again
Page 24-
182
.
- Read readiness code
Page 01-
146
. If the DTC memory has
been erased or the Motronic
Engine Control Module (ECM) -
J220- was disconnected from
battery (B+) positive, the
readiness code must be
generated again
Page 01-149
.
Output Diagnosis Test Mode (DTM)
01-132
6. Activating Leak detection pump
(LDP) -V144-:
- Press
button.
Output Diagnosis Test Mode
Leak Detection Pump tank ventilation system
Indicated on display:
If the Leak Detection Pump (LDP) -
V144- does not run at intervals:
Repair Manual, Body Exterior;
Repair Group 66; Exterior
equipment, Wheel housing liner
The LDP must click, at intervals,
until the next final control element
is activated by pressing
button.
- Remove rear right wheel housing
liner:
- Disconnect 3-pin connector from
Leak Detection Pump (LDP) -
V144- (arrow).
Output Diagnosis Test Mode (DTM)
01-133
LED flashes:
- Connect LED test light VAG 1527
terminals 2 and 3 of detached
connector using adapter cables
from VAG 1594.
LED must flash (bright/darker)
- Press -C- button to abort output
Diagnosis Test Mode (DTM).
Output Diagnosis Test Mode was aborted
Indicated on display:
Repair Manual, 2.8 Liter VR6 4V
Engine Mechanical, Engine Code(s):
BDF; Repair Group 20
- Switch off ignition.
- Replace Leak Detection Pump
(LDP) -V144-:
- Check DTC memory, repair
Diagnostic Trouble Codes (DTCs)
if necessary and then erase DTC
memory
Page 01-23
, DTC
memory, checking and erasing.
- Read readiness code
Page 01-
146
. If the DTC memory has
been erased or the Motronic
Engine Control Module (ECM) -
J220- was disconnected from
battery (B+) positive, the
readiness code must be
generated again
Page 01-149
.
Output Diagnosis Test Mode (DTM)
01-134
LED does not flash:
- Press -C- button to abort output Diagnosis Test
Mode (DTM).
Output Diagnosis Test Mode was aborted
Indicated on display:
Repair Manual, Electrical Equipment; Repair
Group 92
- Switch off ignition.
- Remove wiper arms and cowl panel:
- Connect test box VAG 1598/31 to control
module wiring harness. Engine Control Module
(ECM) -J220- remains disconnected.
Output Diagnosis Test Mode (DTM)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст