Volkswagen Golf / Golf GTI / Jetta. Manual — part 205
24-74
Continuation of check when
display reads approx. -42.0 C
- Disconnect 4-pin connector
(arrow( from Engine Coolant
Temperature (ECT) sensor -G62-
/ Engine Coolant Temperature
(ECT) sensor -G2-.
If display jumps to approx. 136.0
C:
- Jumper connector terminals 3 and
4 using adapter cables from VAG
1594 and observe display.
- Press
button.
- Press buttons -0- and -6- for
function "End output" and confirm
entry with -Q- button.
- Switch off ignition.
Components, checking
24-75
- Replace Engine Coolant Temperature (ECT)
sensor -G62- / Engine Coolant Temperature
(ECT) sensor -G2-
Page 24-16
, item 14 .
- Check DTC memory, repair malfunctions if
necessary and then erase DTC memory
Page
01-23
.
- Read readiness code
Page 01-146
. If DTC
memory has been erased or Motronic Engine
Control Module (ECM) -J220- was disconnected
from battery positive (B+), readiness code must
be generated again
Page 01-149
.
If display remains at approx. -42.0 C:
- Press
button.
- Press buttons -0- and -6- for function "End
output" and confirm entry with -Q- button.
- Switch off ignition.
- Check wiring referring to Electrical Wiring
Diagrams
Page 24-77
.
Components, checking
24-76
Continuation of check when
display reads approx. 136.0 C
If display jumps to approx. -42.0
C:
- Disconnect 4-pin connector
(arrow) from Engine Coolant
Temperature (ECT) sensor -G62-
/ Engine Coolant Temperature
(ECT) sensor -G2-.
- Press
button.
- Press buttons -0- and -6- for
function "End output" and confirm
entry with -Q- button.
- Switch off ignition.
- Replace Engine Coolant
Temperature (ECT) sensor -G62-
/ Engine Coolant Temperature
(ECT) sensor -G2-
Page 24-
16
, item 14 .
- Check DTC memory, repair
malfunctions if necessary and
then erase DTC memory
Page
01-23
.
- Read readiness code
Page 01-
146
. If DTC memory has been
erased or the Motronic Engine
Control Module (ECM) -J220- was
disconnected from battery
positive (B+), readiness code
must be generated again
Page
01-149
.
Components, checking
24-77
If display remains at approx. 136.0 C:
- Press
button.
- Press buttons -0- and -6- for function "End
output" and confirm entry with -Q- button.
- Switch off ignition.
- Check wiring referring to Electrical Wiring
Diagrams
Page 24-77
.
Checking wiring
- Remove wiper arms and cowl panel:
Repair Manual, Electrical Equipment; Repair
Group 92
- Connect VAG 1598/31 test box to control
module wiring harness. Engine Control Module
(ECM) -J220- remains disconnected.
Components, checking
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст