Volkswagen Golf / Golf GTI / Jetta. Manual — part 210
24-94
If the specifications are not
obtained:
If no sensor Diagnostic Trouble
Code (DTC) is detected:
Repair Manual, Electrical
Equipment; Repair Group 92
- Measure sensor resistance
between connector terminals 2
and 3 to sensor.
Specification: 480 to 1000
- Check sensor for short circuit
between terminals 1 and 2 as well
as 1 and 3.
Specification:
- Replace Engine Speed (RPM)
Sensor -G28-
Page 24-16
,
item 16 .
- Check DTC memory, repair
malfunctions if necessary and
then erase DTC memory
Page
01-23
.
- Read readiness code
Page 01-
146
. If DTC memory has been
erased or Motronic Engine
Control Module (ECM) -J220- was
disconnected from battery
positive (B+), readiness code
must be generated again
Page
01-149
.
- Remove wiper arms and cowl
panel:
Components, checking
24-95
- Connect VAG 1598/31 test box to
control module wiring harness.
Engine Control Module (ECM) -
J220- remains disconnected.
- Check wiring for open circuit
between test box and 3-pin
connector referring to Electrical
Wiring Diagrams.
Terminal 1 and socket 108
Terminal 2 and socket 90
Terminal 3 and socket 82
Wire resistance: max. 1.5
- Additionally check wiring for short
to one another, to vehicle Ground
(GND) and to battery positive.
Specification:
Components, checking
24-96
If no wiring malfunction is detected:
- Remove sensor and check sensor wheel for
secure mounting, damage and run-out.
Note:
There is a larger gap on the sensor wheel. This
gap is the reference mark and does not mean
that the sensor wheel is damaged.
If no Diagnostic Trouble Code (DTC) is detected
on sensor wheel:
- Replace Motronic Engine Control Module (ECM)
-J220-
Page 24-173
.
- Check DTC memory, repair malfunctions if
necessary and then erase DTC memory
Page
01-23
.
- Erase learned values and adapt Motronic
Engine Control Module (ECM) -J220- again
Page 24-182
.
- Read readiness code
Page 01-146
. If DTC
memory has been erased or Motronic Engine
Control Module (ECM) -J220- was disconnected
from battery positive (B+), readiness code must
be generated again
Page 01-149
.
Components, checking
24-97
Fuel injectors, checking
Special tools, materials and equipment
VAG 1526 or Fluke 83 Hand multimeter or VAG
1715 multimeter
VAG 1527 LED test light
VAG 1594 Adapter set
VAG 1598/31 test box
Electrical Wiring Diagrams
Test requirements
The fuses must be OK.
The battery voltage must be at least 11.5 V.
All electrical accessories, e.g. lights and rear
window defroster must be switched off.
If the vehicle is equipped with air conditioning,
it must be turned off.
Selector lever must be in position "P" or "N" on
vehicles with an automatic transmission.
Components, checking
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст