Volkswagen Golf / Golf GTI / Jetta. Manual — part 209
24-90
If no wiring malfunction is detected:
- Check wiring for open circuit
between test box and 5-pin
connector referring to Electrical
Wiring Diagrams.
Terminal 1 and socket 26
Terminal 3 and socket 27
Wire resistance: max. 1.5
- Additionally check wiring for short
to one another, to vehicle Ground
(GND) and to battery positive.
Specification:
- Perform a resistance
measurement on Intake Air
Temperature (IAT) sensor -G42-
terminals 1 (signal) and 3
(Ground).
Components, checking
24-91
Scale A shows resistance values for
temperature range 0 to 50 C and
scale B the values for temperature
range 50 to 100 C.
Examples:
If the specification is not obtained:
30 C is in range A and
corresponds to a resistance of
1.5 to 2.0 k
80 C is in range B and
corresponds to a resistance of
275 to 375
- Replace Mass Air Flow (MAF)
sensor -G70-
Page 24-30
,
item 6 .
- Check DTC memory, repair
malfunctions if necessary and
then erase DTC memory
Page
01-23
.
- Read readiness code
Page 01-
146
. If DTC memory has been
erased or Motronic Engine
Control Module (ECM) -J220- was
disconnected from battery
positive (B+), readiness code
must be generated again
Page
01-149
.
Components, checking
24-92
If there is no Diagnostic Trouble Code (DTC) in
the wiring and the resistance measurement
values are OK.:
- Replace Motronic Engine Control Module (ECM)
-J220-
Page 24-173
.
- Check DTC memory, repair malfunctions if
necessary and then erase DTC memory
Page
01-23
.
- Erase learned values and adapt Motronic
Engine Control Module (ECM) -J220- again
Page 24-182
.
- Read readiness code
Page 01-146
. If DTC
memory has been erased or Motronic Engine
Control Module (ECM) -J220- was disconnected
from battery positive (B+), readiness code must
be generated again
Page 01-149
.
Components, checking
24-93
Engine Speed (RPM) Sensor -G28-,
checking
Function
The Engine Speed (RPM) Sensor -G28- is a
speed and reference mark sensor. The engine
will not start if there is no speed signal. If the
speed signal fails when the engine is running, it
will cause the engine to stall immediately.
Special tools, materials and equipment
VAG 1526 or Fluke 83 Hand multimeter or VAG
1715 multimeter
VAG 1594 Adapter set
VAG 1598/31 test box
Electrical Wiring Diagrams
Test sequence
- Separate gray 3-pin connector (arrow) to Engine
Speed (RPM) Sensor.
Components, checking
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст