Volkswagen Golf / Golf GTI / Jetta. Manual — part 769
- Unclip cover cap - 2 - and remove bolt -
3 - (40 Nm).
- Remove belt relay - 1 - , tension disc - 4
- and spacer sleeve - 5 - .
- Remove seal - 6 - in area of trim.
- Position Release tool T10078 at
transition from molded headliner to C-
pillar trim.
- Distance from rear windshield to center
of tool must be approx. 66 mm (dimension
- a - ).
- Slide Release tool T10078 between
molded headliner and C-pillar trim until it
engages audibly - arrowA - .
Pillar and side trim
13/2/2005
- Pull tool back - arrowB - , reby removing
lower part of steel clip - 1 - .
- Unclip trim - 1 - from C-pillar - 2 - .
Note:
n
Check clips - 3 - and replace if
necessary.
Pillar and side trim
13/2/2005
- Disengage locking mechanism of steel
clip - 1 - by forcefully pushing toger using
standard pliers - 2 - .
- Remove steel clip - 1 - from C-pillar.
Note:
n
It is not possible to remove steel clip
- 1 - without destroying it.
Pillar and side trim
13/2/2005
Installing
Note:
n
For safety reasons, steel clips - 1 -
and - 3 - must be replaced after
each removal and installation of C-
pillar trim.
n
Steel clips and upper C-pillar trim
parts can no longer be ordered
separately for vehicles with side
curtain protection
⇒ parts catalog.
- Slide steel clip - 1 - into first detent - 2 -
of C-pillar trim - arrowA - .
- Insert steel clip - 3 - into mount.
Pillar and side trim
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст