Volkswagen Golf / Golf GTI / Jetta. Manual — part 281
34-38
- Remove left mount -1- from
transmission (arrows).
- Pull off gate selector cable -A-
with relay lever in direction of
arrow.
- Tie up selector cable with
transmission selector lever and
gate selector cable with relay
lever.
- Incline engine/transmission
assembly further by lowering it via
left spindle of support bar 10-
222A.
Transmission, removing and installing
34-39
Note:
Do not damage any of the
connecting lines and hoses when
moving engine/transmission
assembly.
Set up transmission support 3282
with adjustment plate 3282/27 to
remove transmission 02M.
- Bolt support rail T10036 to both
pendulum support securing holes
on subframe (bolts -A-).
- Install support 3300 A so that it is
almost touching assembly
mounting and secure (arrows).
- Press engine/transmission
forward carefully.
- Remove lower rear
engine/transmission securing
bolts (arrow -A-).
- Remove lower
engine/transmission securing
bolts.
- Align arms of transmission
support according to holes in
adjustment plate.
- Bolt support elements -A-, as
illustrated, on adjustment plate.
Transmission, removing and installing
34-40
Note:
Do not damage power steering line
when lowering transmission.
- Place transmission jack under
vehicle. Arrow symbol -B- (
Illustration N34-1052) on
adjustment plate points to front of
vehicle.
- Align adjustment plate parallel to
transmission.
- Secure transmission to
transmission support 3282 with
bolt -A-.
- Remove engine/transmission
connecting bolt (arrow).
- Press transmission off dowel
sleeves and carefully swing
toward subframe.
- Lower transmission slightly and
incline to left via spindles of
transmission support 3282.
- Lower transmission carefully,
guiding right side flanged shaft in
area of flywheel and left side
flanged shaft in area of subframe.
- When lowering, change position
of transmission using
transmission support 3282
spindles.
Transmission, removing and installing
34-41
Transporting the transmission
- Bolt transmission lifting device
3336 to clutch housing.
- Set support beam on sliding piece
with locking pin (arrow).
No. of holes visible = 6
- Take transmission out with
workshop crane and transmission
lifting device 3336.
- Lower transmission.
Transmission, removing and installing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст