Volkswagen Golf / Golf GTI / Jetta. Manual — part 282

34-42

Installing

- Clean input shaft splines and lightly grease with

G 000 100 grease.

Clutch plate must be able to slide lightly back

and forth on input shaft.

- Check whether dowel sleeves for aligning

engine/transmission are installed in cylinder
block and install if necessary.

- Make sure that intermediate plate is correctly

positioned on engine.

Note:

Do not damage power steering line.

- Bolt support rail T10036 to both pendulum

support securing holes on subframe (arrows).

- Install support 3300 A so that it is almost

touching assembly mounting and secure
(arrows).

- Press engine forward carefully.

Transmission, removing and installing

34-43

Set up transmission support 3282 with
adjustment plate 3282/27 to install transmission
02M.

- Align arms of transmission support according to

holes in adjustment plate.

- Bolt support elements -A-, as illustrated, on

adjustment plate.

- Place transmission on transmission jack.

- Align adjustment plate and transmission parallel

with one another.

Note:

Do not damage power steering line.

- Place transmission jack under vehicle. Arrow

symbol -B- (

Fig. N34-1052) on adjustment

plate points to front of vehicle.

- Secure transmission to transmission support

3282 with bolt -A-.

- Incline transmission to left via spindles of

transmission mounting 3282.

- Install transmission.

Transmission, removing and installing

34-44

- Install lower rear engine/transmission

connecting bolt (arrow -A-).

- Install lower engine/transmission securing

bolts.

- Remove pressing device 3300 A (arrows).

- Remove bolts -A- and remove support rail

T10036.

- Install gate selector cable -A- with relay lever in

direction of arrow.

Transmission, removing and installing

34-45

- Install left mount -1- on

transmission (arrows).

- Align engine/transmission in

installation position.

- Install new hex bolts (arrows) for

left assembly mounting -2- in
mount -1-.

Transmission, removing and installing