Volkswagen Golf / Golf GTI / Jetta. Manual — part 229
24-170
"Voltage supply open circuit,"
followup procedure
All values learned by the Motronic
Engine Control Module (ECM) -
J220- and the basic setting values
as well as the readiness code will be
erased if the voltage supply is
interrupted. Therefore, depending
upon the vehicle mileage it can lead
to serious engine running problems.
Special tools and equipment
Note:
All functions which could previously
be performed with VAG 1551/1552
can also be performed with the VAS
5051.
VAG 1551 Scan tool (or VAG
1552) with VAG 1551/3 adapter
cable
Motronic Engine Control Module (ECM) -J220-
24-171
Work sequence
Perform the following operations after
interrupting voltage supply:
- Switch ignition on for at least 10 seconds.
- Switch off ignition.
- Erase learned values and adapt Motronic
Engine Control Module (ECM) -J220- again
Page 24-182
.
- Perform idle speed check
Page 24-125
.
Note:
During idle speed check the Evaporative
Emission (EVAP) Canister Purge Regulator
Valve -N80- and the air conditioner compressor
are switched off and the Oxygen Sensor control
learning procedure is initiated.
- Generate readiness code
Page 01-149
.
- Perform a longer road test until poor driving
characteristics are eliminated.
Observe the valid safety precautions when
performing a road test
Page 24-33
.
Motronic Engine Control Module (ECM) -J220-
24-172
During the road test the following operating
conditions must be fulfilled:
Engine Coolant Temperature (ECT) must
exceed 80 C .
When the temperature is reached, the
operating conditions
Idling
Part throttle
Wide open throttle
Overrun
must be obtained several times.
At wide open throttle the speed must exceed
3500 rpm.
Motronic Engine Control Module (ECM) -J220-
24-173
Motronic Engine Control
Module (ECM) -J220-,
replacing
Special tools and equipment
Note:
All functions which could previously
be performed with VAG 1551/1552
can also be performed with the VAS
5051.
VAG 1551 Scan tool (or VAG
1552) with VAG 1551/3 adapter
cable
Motronic Engine Control Module (ECM) -J220-
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст