Volkswagen Golf / Golf GTI / Jetta. Manual — part 230
24-174
Removing
Print out control module identification and
thereby previous control module coding as
follows:
- Connect VAG 1551 Scan tool (or VAG 1552).
Then switch ignition on and select Motronic
Engine Control Module (ECM) -J220- with
"Address word" 01. ((VAG 1551 and Motronic
Engine Control Module (ECM) -J220-,
connecting and selecting
Page 01-12
).
022906032BL MOTRONIC ME7.1.1 G 0006
Coding 00032
WSC 00000
The control module identification and coding are
shown on the display, e.g.:
Repair Manual, Electrical Equipment; Repair
Group 92
- Print out control module identification by
pressing Diagnostic Trouble Code (DTC) reader
print button.
- Press
button.
- Press buttons -0- and -6- for function "End
output" and confirm entry with -Q- button.
- Switch off ignition.
- Remove wiper arms and cowl panel:
- Release connector and remove from control
module.
Motronic Engine Control Module (ECM) -J220-
24-175
Installing
Repair Manual, Electrical
Equipment On Board Diagnostic
(OBD);Repair Group 01
Vehicles with cruise control
system (CCS)
Electrical Wiring Diagrams,
Troubleshooting & Component
Locations
- Press retaining tab (arrow) to left
and pull control module out.
- Place new control module into
retaining frame.
- Install control module connector
and lock.
- Check previous coding and
coding of new control module
Page 24-177
.
- Adapt new control module to
electronic Immobilizer:
- Erase learned values and adapt
Motronic Engine Control Module
(ECM) -J220- again
Page 24-
182
.
- Check that system has been
activated. If "G" is not evident in
control module identification,
activate cruise control system:
Motronic Engine Control Module (ECM) -J220-
24-176
Vehicles with an automatic transmission
- Also adapt automatic transmission control
module:
Repair Manual, 5 Spd. Automatic
Transmission 09A On Board Diagnostic (OBD);
Repair Group 01
Continuation for all vehicles
- Check DTC memory, repair malfunctions if
necessary and then erase DTC memory
Page
01-23
.
- Perform idle speed check
Page 24-125
.
- Generate readiness code
Page 01-149
.
Motronic Engine Control Module (ECM) -J220-
24-177
Motronic Engine Control Module (ECM)
J220-, coding
Note:
A 5-character code must always be displayed
during the control module identification.
Measured value block 125 indicates which
control modules are connected via CAN-
the Motronic Engine Control Module (ECM)
J220-
Page 01-267
,Evaluating measured
value (data) block, display groups 120 to 129
Communication-.
The control module must be coded as follows if
the vehicle relevant coding is not displayed or
the control module has been replaced.
Special tools and equipment
Note:
All functions which could previously be performed
with VAG 1551/1552 can also be performed with
the VAS 5051.
VAG 1551 Scan tool (or VAG 1552) with VAG
1551/3 adapter cable
Motronic Engine Control Module (ECM) -J220-
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст