Volkswagen Golf / Golf GTI / Jetta. Manual — part 243
24-226
If the resistance measurement is not within
the specified range:
- Replace Motronic Engine Control Module (ECM)
-J220-
Page 24-173
.
- Check DTC memory, repair malfunctions if
necessary and then erase DTC memory
Page
01-23
.
- Erase learned values and adapt Motronic
Engine Control Module (ECM) -J220- again
Page 24-182
.
- Read readiness code
Page 01-146
. If DTC
memory has been erased or Motronic Engine
Control Module (ECM) -J220- was disconnected
from battery positive (B+), readiness code must
be generated again
Page 01-149
.
Additional signals, checking
24-227
If the resistance value is within the specified
range:
- Repair Diagnostic Trouble Code (DTC):
Electrical Wiring Diagrams, Troubleshooting &
Component Locations
- Check DTC memory, repair malfunctions if
necessary and then erase DTC memory
Page
01-23
.
- Erase learned values and adapt Motronic
Engine Control Module (ECM) -J220- again
Page 24-182
.
- Read readiness code
Page 01-146
. If DTC
memory has been erased or Motronic Engine
Control Module (ECM) -J220- was disconnected
from battery positive (B+), readiness code must
be generated again
Page 01-149
.
Additional signals, checking
28-1
Ignition system, servicing
General notes on ignition system
Note:
Only the components which specifically relate
to the ignition system are dealt with here. For
the other components of the injection and
ignition system
Repair Group 24.
The Engine Control Module (ECM) is equipped
with On Board Diagnostic (OBD).
Components marked with * are checked via On
Board Diagnostic (OBD)
Page 01-23
.
Components marked with **can be checked via
Output Diagnostic Test Mode (DTM)
Page
01-100
.
For trouble-free operation of the electrical
components, a voltage of at least 11.5 V is
necessary.
Disconnecting and connecting the battery must
only be done with the ignition switched off,
otherwise the Engine Control Module (ECM)
could be damaged.
Check DTC memory before carrying out repairs
and for troubleshooting
Page 01-23
.
During some checks it is possible that the
control module will detect and store a
Diagnostic Trouble Code (DTC). Therefore after
completing all checks and repairs the DTC
memory must be checked and if necessary
erased
Page 01-23
, and then generate the
readiness code
Page 01-149
.
Ignition system, servicing
28-2
If the engine starts, runs for a short period and
then stops, after troubleshooting, repairs or
component tests, then the malfunction may lie
with the Immobilizer which is blocking the
Engine Control Module (ECM). In such cases
the DTC memory must be checked and, if
necessary, the control module adapted.
Repair Manual, Electrical Equipment On
Board Diagnostic (OBD);Repair Group 01
Safety precautions
Page 28-12
.
Test data, spark plugs
Page 28-15
.
Ignition system, servicing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст