Volkswagen Golf / Golf GTI / Jetta. Manual — part 17
drive
plate
Page 13-
31
Sealing flanges and dual-mass flywheel, removing and installing
13-26
10
-
60 Nm
plus
additional
1
/
4
turn
(90 )
further
Replace
Use
counter
support
T10069
to
loosen
and
tighten
11 - 23 Nm
Sealing flanges and dual-mass flywheel, removing and installing
13-27
Crankshaft
oil seal
(vibration
damper
end),
replacing
Special tools
and
equipment
3203 Oil
seal
extractor
3266
Sleeve
T10069
Counter
support
T10053/1
Guide
sleeve
VAG 1601
Torque
wrench
(150...800
Nm)
VAG 1332
Torque
wrench
(40...200
Nm)
Sealing flanges and dual-mass flywheel, removing and installing
13-28
Removing
- Remove ribbed belt
Page 13-
19
.
- Remove vibration damper. To do
this, hold vibration damper with
counter support T10069.
- Unscrew inner part of oil seal
extractor 3203 three turns
(approx. 4 mm) out of the outer
part and lock with knurled screw.
- Lubricate threaded head of oil
seal extractor 3203, place it in
position and exerting firm
pressure screw it as far as
possible into oil seal.
- Loosen knurled screw and turn
inner part against crankshaft until
oil seal is pulled out.
Sealing flanges and dual-mass flywheel, removing and installing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст