Volkswagen Golf / Golf GTI / Jetta. Manual — part 238
24-206
Brake Light Switch -F- and
Brake Pedal Switch (cruise
control/Diesel Direct Fuel
Injection) -F47- signal,
checking
Special tools, materials and
equipment
Note:
All functions which could previously
be performed with VAG 1551/1552
can also be performed with the VAS
5051.
VAG 1551 Scan tool (or VAG
1552) with VAG 1551/3 adapter
cable
VAG 1526 or Fluke 83 Hand
multimeter or VAG 1715
multimeter
VAG 1594 Adapter set
VAG 1598/31 test box
Electrical Wiring Diagrams
Additional signals, checking
24-207
Test requirements
Test sequence
The fuses must be OK.
The battery voltage must be at
least 11.5 V.
All electrical accessories, e.g.
lights and rear window defroster
must be switched off.
If the vehicle is equipped with air
conditioning, it must be turned
off.
Selector lever must be in
position "P" or "N" on vehicles
with an automatic transmission.
- Connect VAG 1551 Scan tool (or
VAG 1552). Then switch ignition
on and select Motronic Engine
Control Module (ECM) -J220- with
"Address word" 01. ((VAG 1551
and Motronic Engine Control
Module (ECM) -J220-, connecting
and selecting
Page 01-12
).
Rapid data transfer
HELP
Select function XX
Indicated on display:
Additional signals, checking
24-208
- Press buttons -0- and -8- for function "Read
measured value (data) block" and confirm entry
with -Q- button.
Read measured value block
Input display group number XXX
Indicated on display:
- Press buttons -0-, -6- and -6- for "Display group
number 66" and confirm entry with -Q- button.
Read measured value block 66
1
2
3
4
Indicated on display: (1 to 4
display zones)
If the specifications are not obtained:
- Observe display in display zone 2: (7th and 8th
positions from left).
Specification: xxxxxx00
- Depress brake pedal and observe display in
display zone 2.
Specification: xxxxxx11
- Press
button.
- Press buttons -0- and -6- for function "End
output" and confirm entry with -Q- button.
- Switch off ignition.
- Remove cover in footwell (driver's side).
Additional signals, checking
24-209
- Disconnect 4-pin connector from Brake Light
Switch -F- and Brake Pedal Switch (cruise
control/Diesel Direct Fuel Injection) -F47-
If the specifications are not obtained:
- Measure resistance between terminals 1 and 4
of switch.
Specification:
Brake pedal not depressed:
Brake pedal depressed: max. 1.5
- Measure resistance between terminals 2 and 3
of switch.
Specification:
Brake pedal not depressed: Max. 1.5
Brake pedal depressed:
- Replace Brake Light Switch -F- and Brake Pedal
Switch (cruise control/Diesel Direct Fuel
Injection) -F47-.
- Check DTC memory, repair malfunctions if
necessary and then erase DTC memory
01-23
.
- Read readiness code
Page 01-146
. If DTC
memory has been erased or Motronic Engine
Control Module (ECM) -J220- was disconnected
from battery positive (B+), readiness code must
be generated again
Page 01-149
.
Additional signals, checking
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст