Volkswagen Golf / Golf GTI / Jetta. Manual — part 237
24-202
- Disconnect 4-pin connector from
Clutch Vacuum Vent Valve Switch
-F36- (arrow).
If the specifications are not
obtained:
Note:
Observe installation position of
Clutch Vacuum Vent Valve Switch -
F36- through upper assembly hole of
bearing bracket.
- Measure resistance between
switch terminals 2 and 3.
Specification:
Clutch not depressed: max. 1.5
Clutch depressed:
- Replace Clutch Vacuum Vent
Valve Switch -F36-.
Additional signals, checking
24-203
- Check DTC memory, repair malfunctions if
necessary and then erase DTC memory
01-23
.
- Read readiness code
Page 01-146
. If DTC
memory has been erased or Motronic Engine
Control Module (ECM) -J220- was disconnected
from battery positive (B+), readiness code must
be generated again
Page 01-149
.
If the specifications are obtained:
If the specification is not obtained:
- Connect multimeter to measure voltage at
connector terminal 2 and engine Ground (GND).
- Switch ignition on.
Specification: at least 11.5 V
- Switch ignition off.
- Check wire for open circuit between 4-pin
connector terminal 2 and Fuel Pump (FP) Relay
-J17- referring to Electrical Wiring Diagrams.
Wire resistance: max. 1.5
Additional signals, checking
24-204
If the specification is obtained:
- Remove wiper arms and cowl
panel:
Repair Manual, Electrical
Equipment; Repair Group 92
- Connect VAG 1598/31 test box to
control module wiring harness.
Engine Control Module (ECM) -
J220- remains disconnected.
- Check wiring for open circuit
between test box and 4-pin
connector referring to Electrical
Wiring Diagrams.
Terminal 3 and socket 39
Wire resistance: max. 1.5
- Additionally check wiring for short
to one another, to vehicle Ground
(GND) and to battery positive.
Specification:
Additional signals, checking
24-205
If there is no Diagnostic Trouble Code (DTC) in
the wiring and the resistance measurement
values are OK.:
- Replace Motronic Engine Control Module (ECM)
-J220-
Page 24-173
.
- Check DTC memory, repair malfunctions if
necessary and then erase DTC memory
Page
01-23
.
- Erase learned values and adapt Motronic
Engine Control Module (ECM) -J220- again
Page 24-182
.
- Read readiness code
Page 01-146
. If DTC
memory has been erased or Motronic Engine
Control Module (ECM) -J220- was disconnected
from battery positive (B+), readiness code must
be generated again
Page 01-149
.
Additional signals, checking
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст