Volkswagen Golf / Golf GTI / Jetta. Manual — part 1135
94-60
Steering column switches,
multi-pin connector
assignments
Windshield wiper/washer and
multi-function indicator (MFI)
switches
A - Connector, 4 pin
B - Connector, 8 pin
1 - MFI call-up button - right
2 - MFI call-up button - left
3 - MFI call-up button - terminal 31
(Ground)
4 - MFI safe switch - Reset
5 - Windshield wiper intermittent
regulator - to intermittent wash/wipe
relay
6 - Windshield wiper intermittent
regulator - terminal 31 (Ground)
1 - Windshield wiper switch -
terminal 53
2 - Windshield wiper switch -
terminal 31
3 - Windshield wiper switch -
terminal 53e
4 - Windshield wiper switch -
terminal 53c
5 - Windshield wiper switch - rear
window wiper
6 - Windshield wiper switch -
terminal 53b
7 - Windshield wiper switch -
intermittent operation
8 - Windshield wiper switch -
terminal 53a
Steering column switches
13/2/2005
94-61
Turn Signal, headlight, flasher and
parking light switch
C - Connector, 12 pin
1 - Switch for headlights/flasher -
terminal 30
2 - Switch for headlights/flasher -
terminal 30
3 - Turn Signal switch - terminal L
4 - Parking light switch - terminal P
5 - Turn Signal switch - terminal 49a
6 - Horn contact - terminal 71
7 - Switch for headlights/flasher -
terminal 56
8 - Switch for headlights/flasher -
terminal 56b
9 - Parking light switch - terminal PL
10 - Parking light switch - terminal PR
11 - Turn Signal switch - terminal R
12 - Switch for headlights/flasher -
terminal 56a
Steering column switches
13/2/2005
94-62
Cruise control switch
D - Connector, 10 pin
1 - Open
2 - Switch for CCS - On / Off
3 - Switch for CCS - Set / delay
4 - Switch for CCS - Reset /
Resume saved speed / Accelerate
5 - Switch for CCS - Reset /
Resume saved speed / Accelerate
6 - Switch for CCS - On / Off
7 - Switch for CCS
8 - 10: Open
Steering column switches
13/2/2005
94-63
Ignition/starter switch and
lock cylinder
Lock cylinder, removing and installing
CAUTION!
Before beginning repairs on the electrical
system:
Obtain the anti-theft radio security code.
Switch off all electrical consumers.
Switch ignition off and remove ignition
key.
Disconnect negative ( - ) battery terminal.
When disconnecting and reconnecting
battery terminals, observe all applicable
Notes and torque specifications, as well as
instructions on performing OBD program
and electrical system function checks as
specified in this Repair Manual
Page 27
39
.
Removing
- Disconnect battery
Page 27-39
.
- Remove steering column switches
Page 94
55
.
Note:
If equipped, the induction coil for anti-theft
immobilizer is integrated with the lock cylinder and
cannot be serviced separately.
- Where applicable, carefully disconnect electrical
connection for the induction coil for anti-theft
immobilizer from lock cylinder.
Ignition/starter switch and lock cylinder
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст