Volkswagen Golf / Golf GTI / Jetta. Manual — part 1136
94-64
- Insert ignition key in lock cylinder and turn to
position "Drive".
Position of key in lock cylinder:
1 - Position "Stop"
2 - Position "Drive"
3 - Position "Start"
Note:
To enable steel wire to be inserted straight into
hole, ignition key may have to be dismantled and
inserted into lock cylinder without key head.
Repair Manual, Body Interior, Repair Group 69
- Insert steel wire (approx.
1.2 mm) in drilling
next to ignition key -arrow-.
- Dismantling ignition key
Ignition/starter switch and lock cylinder
13/2/2005
94-65
Installing
Note:
Where applicable, ensure
immobilizer induction coil electrical
connection orientation in lock
cylinder housing guide.
- Release lock cylinder securing
lever using wire -arrow- and
remove lock cylinder from
steering lock housing.
1 - Lock cylinder
2 - Steel wire (approx.
1.2 mm)
3 - Securing lever
- Insert ignition key in lock cylinder
and turn to position "Drive".
- Release securing lever using wire
(approx.
1.2 mm) and insert
lock cylinder in steering lock
housing.
- Pull wire out of lock cylinder and
ensure lock cylinder is secured
properly in steering lock housing.
Ignition/starter switch and lock cylinder
13/2/2005
94-66
- Where applicable, reconnect
immobilizer reading coil electrical
connector -arrow- to lock cylinder.
- Install steering column switches
and steering wheel
Page 94-
55
.
- Reconnect battery
Page 27-
39
.
Ignition/starter switch and lock cylinder
13/2/2005
94-67
Ignition/starter switch, removing and
installing
CAUTION!
Before beginning repairs on the electrical
system:
Obtain the anti-theft radio security code.
Switch off all electrical consumers.
Switch ignition off and remove ignition
key.
Disconnect negative ( - ) battery terminal.
When disconnecting and reconnecting
battery terminals, observe all applicable
Notes and torque specifications, as well as
instructions on performing OBD program
and electrical system function checks as
specified in this Repair Manual
Page 27
39
.
Removing
- Disconnect battery
Page 27-39
.
- Remove steering column switches
Page 94
55
.
- Disconnect electrical connector from
ignition/starter switch.
- Remove locking paint on securing screws
- Loosen two securing screws -A- slightly and pull
ignition/starter switch out from steering lock
housing in direction of -arrow-.
Ignition/starter switch and lock cylinder
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст