Volkswagen Golf / Golf GTI / Jetta. Manual — part 408
45-23
- Using a small screwdriver, push
purple latch in direction of arrow.
Pin assignment of harness
connector T25 and ABS Control
Module (w/EDL) -J104-
Pin
Connected to
component:
19 +
20
Right Front ABS Wheel
Speed Sensor -G45-
1 + 2 Left Front ABS Wheel
Speed Sensor -G47-
ABS system components for front axle, removing and installing
45-24
- Using extractor tool from wiring
harness repair set VAS 1978,
push out applicable terminals.
- Disconnect wheel speed sensor
wiring connector.
- Replace faulty wheel speed
sensor wiring.
- Connect speed sensor to speed
senor wiring.
Note:
Make sure the wiring is not twisted in
the wheel well.
- Secure speed sensor wiring
(arrows).
ABS system components for front axle, removing and installing
45-25
- Install pin connectors in connector
housing.
- Using installation tool from VAS
1978, push individual wire seals
to stop.
- Secure terminals by engaging
purple latch and install cover of
multi-pin connector.
ABS system components for front axle, removing and installing
45-26
ABS system
components
on rear axle,
removing
and
installing
1 - ABS
wheel
speed
sensor
Before
inserting
sensor,
clean
mounting
hole
inner
surface
and coat
with
lubricant
G 000
650
2 - Hex
socket
head
bolt, 8
Nm (70
in lb)
3 - Stub
axle
4 - Splash
shield
5 - Wheel
hub with
wheel
bearing
and
speed
sensor
rotor
Replace
each time
after
ABS system components for front axle, removing and installing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст