Volkswagen Golf / Golf GTI / Jetta. Manual — part 200
24-54
Test sequence
- Connect VAG 1551 Scan tool ( or VAG 1552)
and select engine electronics control module
with "Address word" 01. Engine must be running
at idle speed: ((VAG 1551 and Motronic Engine
Control Module (ECM) -J220-, connecting and
selecting
Page 01-12
).
Rapid data transfer
HELP
Select function XX
Indicated on display:
- Press buttons -0- and -8- for function "Read
measured value (data) block" and confirm entry
with -Q- button.
Read measured value block
Input display group number XXX
Indicated on display:
- Press buttons -0-, -0- and -2- for "Display group
number 2" and confirm entry with -Q- button.
Read measured value block 2
1
2
3
4
Indicated on display: (1...4
display zones)
- Check mass of air drawn in, in display zone 4
Specification: 3.0 to 5.0 g/s
- Press
button.
- Press buttons -0- and -6- for function "End
output" and confirm entry with -Q- button.
Components, checking
24-55
- Switch off ignition.
If the specification is achieved but an Mass Air
Flow (MAF) related Diagnostic Trouble Code
(DTC) is registered in Diagnostic Trouble Code
(DTC) memory:
- Check voltage supply for Mass Air Flow (MAF)
sensor -G70-
Page 24-55
.
If the specification is not obtained:
- Check signal and Ground (GND) wires for Mass
Air Flow (MAF) sensor -G70-
Page 24-
Checking voltage supply for Mass Air Flow
(MAF) sensor
- Disconnect 5-pin connector from Mass Air Flow
(MAF) sensor -G70- with Intake Air Temperature
(IAT) sensor -G42- (arrow).
Components, checking
24-56
If no voltage is present:
If the voltage supply and wiring is
OK.:
- Connect multimeter to measure
voltage at connector terminal 2
and engine Ground (GND).
- Start engine and run at idle
speed.
Specification: 11.0 to 15.0 V
- Switch off ignition.
- Check wire for open circuit
between 5-pin connector terminal
2 and Fuel Pump (FP) -J17-
referring to Electrical Wiring
Diagrams.
Wire resistance: max. 1.5
- Connect multimeter to measure
voltage at connector terminal 4
and engine Ground (GND).
- Switch on ignition
Specification: at least 4.5 V
- Switch off ignition.
Components, checking
24-57
If no voltage is present:
- Check signal and Ground (GND) wires for Mass
Air Flow (MAF) sensor
Page 24-57
.
Checking signal and Ground (GND) wires for
Mass Air Flow (MAF) sensor
- Remove wiper arms and cowl panel:
Repair Manual, Electrical Equipment; Repair
Group 92
- Connect VAG 1598/31 test box to control
module wiring harness. Engine Control Module
(ECM) -J220- remains disconnected.
- Check wiring for open circuit between test box
and 5-pin connector referring to Electrical Wiring
Diagrams.
Terminal 3 and socket 27
Terminal 4 and socket 53
Terminal 5 and socket 29
Wire resistance: max. 1.5
Components, checking
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст