Volkswagen Golf / Golf GTI / Jetta. Manual — part 199
24-50
Checking voltage supply
If no voltage is present:
Repair Manual, Electrical
Equipment; Repair Group 92
- Connect multimeter to measure
voltage at terminals 1 and 2
(connector to Motronic Engine
Control Module (ECM) -J220-)
using adapter cables from VAG
1594.
- Start engine and run at idle
speed.
- Measure voltage supply and
observe display group 41, display
zone 4.
- Display Htg.aC.ON: Specification:
11.0 to 14.5 V
Display Htg.aC.ON / Htg.aC.OFF
(alternating): Specification:
Between 0.0 to 12.0 V fluctuating
- Switch off ignition.
- Remove wiper arms and cowl
panel:
- Connect VAG 1598/31 test box to
control module wiring harness.
Engine Control Module (ECM) -
J220- remains disconnected.
Components, checking
24-51
If the specification is obtained:
If no wiring malfunction is detected:
- Check wiring for open circuit
between test box and 4-pin
connector referring to Electrical
Wiring Diagrams.
Terminal 2 and socket 63
Wire resistance: max. 1.5
- Check wire for open circuit
between 4-pin connector terminal
1 and Fuel Pump (FP) relay -J17-
referring to Electrical Wiring
Diagrams.
Wire resistance: max. 1.5
- Replace Motronic Engine Control
Module (ECM) -J220-
Page 24-
173
.
- Check DTC memory, repair
malfunctions if necessary and
then erase DTC memory
Page
01-23
.
- Erase learned values and adapt
Motronic Engine Control Module
(ECM) -J220- again
Page 24-
182
.
- Read readiness code
Page 01-
146
. If DTC memory has been
erased or Motronic Engine
Control Module (ECM) -J220- was
disconnected from battery
positive (B+), readiness code
must be generated again
Page
01-149
.
Components, checking
24-52
Mass Air Flow (MAF) sensor -
G70- , checking
Note:
Only gold plated terminals may be
used to service terminals in the
Mass Air Flow (MAF) sensor
connector.
Special tools, materials and
equipment
Note:
All functions which could previously
be performed with VAG 1551/1552
can also be performed with the VAS
5051.
VAG 1551 Scan tool (or VAG
1552) with VAG 1551/3 adapter
cable
VAG 1526 or Fluke 83 Hand
multimeter or VAG 1715
multimeter
VAG 1594 Adapter set
VAG 1598/31 Test box
Electrical Wiring Diagrams
Components, checking
24-53
Test requirements
Electrical Wiring Diagrams,
Troubleshooting & Component
Locations
The fuses must be OK.
The battery voltage must be at
least 11.5 V.
All electrical accessories, e.g.
lights and rear window defroster
must be switched off.
If the vehicle is equipped with air
conditioning, it must be turned
off.
Selector lever must be in
position "P" or "N" on vehicles
with an automatic transmission.
Fuel Pump (FP) -J17- must be
OK., checking:
Coolant temperature must be at
least 85 C,
display group 1,
display zone 2.
Components, checking
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст