Volkswagen Golf / Golf GTI / Jetta. Manual — part 430
45-98
Make sure the wiring is not twisted
when installing the speed sensor
wiring in the wheel housing.
- Connect speed sensor to speed
sensor wiring -1- and close
connector cover -2-.
- Clip in speed sensor wiring
(arrows).
- Cut 2-pin connector off new
speed sensor wiring with wire
stripper pliers.
- Strip 15 mm (5/8 in.) of insulation
from end of wire with wire
strippers and bend back half.
- Connect speed sensor wiring with
help of suitable crimp connector
from wiring harness repair set
VAS 1978.
ABS system components for front and rear axles, removing and installing
45-99
ESP system components,
removing and installing
A description of construction and function of
ESP system is found in Self Study Program
861103 Volkswagen Handling Controls.
When the individual sensors or senders are
changed, a zero compensation must be
carried out for the changed component.
ESP system components, removing and installing
45-100
Sender for rotation rate -G202- and
sensor for transverse acceleration -
G200-, removing and installing
Note:
The removal and installation sequence for the
sender for rotation rate -G202- and the sensor for
transverse acceleration -G200- is identical
except for the mounting bracket for each
component.
Removing
- Request radio code on vehicles with coded radio
if necessary.
- Disconnect battery.
- Remove Qty. 2 screws -1-.
- Unclip top of trim -2-
- Remove Qty. 2 screws -3-
- Unclip top of trim -4-.
ESP system components, removing and installing
45-101
- Remove Qty. 7 screws (arrows).
- Take off reinforcement -1-.
- The sender for rotation rate -
G202- -1- and the sensor for
transverse acceleration -G200- -
2- are located on the steering
column -3- bearing bracket.
a - Steering column
ESP system components, removing and installing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст