Volkswagen Golf / Golf GTI / Jetta. Manual — part 429
45-94
Installing
- Before inserting speed sensor, clean hole inner
surface and coat speed sensor all-round with
solid lubricant paste G 000 650.
- Insert speed sensor into hole in trailing arm and
tighten bolt -1- to 8 Nm (71 in. lb).
- Connect speed sensor to speed sensor wiring
and close connector -1- cover -2-.
ABS system components for front and rear axles, removing and installing
45-95
Rotor on rear axle (all-wheel
drive), checking or removing and
installing
- Raise vehicle.
- Remove wheel.
Repair Manual, Suspension,
Wheels, Steering, Repair Group 42;
Assembly overview for trailing arm
and transverse links; Pressing wheel
bearings out and in.
- Remove bolt -1- from trailing arm.
- Pull ABS speed sensor out of
trailing arm.
- Check rotor is not damaged or
dirty.
- If rotor is damaged, remove wheel
hub with rotor and replace.
ABS system components for front and rear axles, removing and installing
45-96
Removing and installing rear
speed sensor wiring (all-wheel
drive)
Special tools and equipment
Removing
VAS 1978 Wiring harness repair
set
- Obtain radio code on vehicles
with coded radio.
- Disconnect battery.
- Separate speed sensor
wiring/speed sensor connection.
- Raise vehicle.
- Open connector -1- cover -2-
- Separate speed sensor and
speed sensor wiring connector -1-
.
ABS system components for front and rear axles, removing and installing
45-97
- Remove rear side panel trim
Repair Manual, Body Interior,
Repair Group 70, Pillars and side
panel trims
- Separate speed sensor wiring
(arrow) with wire strippers from
VAS 1978 and remove faulty
wiring.
- Strip 15 mm (5/8 in.) of insulation
from end of wire with wire
strippers and bend half of stripped
wire back.
- Guide in new speed sensor
wiring.
ABS system components for front and rear axles, removing and installing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст