Volkswagen Golf / Golf GTI / Jetta. Manual — part 729

1. Roof edge spoiler

¡

Removing

66-8, Roof edge

spoiler, removing

¡

Installing

66-8, Installing roof

edge spoiler

¡

Installation notes

66-8,

Installation notes

¡

Material PU-R-RIM

2. Primer surface on spoiler

3. Circumference of installed roof

edge spoiler

4. Primer surface/residue on rear lid

¡

Preparation

66-8, Preparing

bodywork for adhesive

Special components of Golf "GTI 337 Edition"/Jetta GLI Sport and Golf R32

13/2/2005

Roof edge spoiler, removing

Warning!

When disassembling special components, a cutting
cable must not be used because of danger of
damaging painted surfaces.

- Clean dirt from all seams so that no damage to paint will
occur when removing components.

- Cover all adjacent paint surfaces and gap between roof
and rear lid with tape.

- Spooling tool must be applied in depicted position and
one cord end must be secured.

- Insert cutting cord around spoiler so that cord passes
along outside in seam between spoiler and rear lid and
secure second cord end to wiper axle.

- While cutting free, guide cutting cord into seam using a
plastic wedge.

- In position illustrated, spoiler can be cut free to slightly
past vehicle center.

Special components of Golf "GTI 337 Edition"/Jetta GLI Sport and Golf R32

13/2/2005

- Then, position spooling tool corresponding to illustration
and swap cord ends. Then cut free spoiler from other outer
side toward center.

- Remove spoiler.

Installing roof edge spoiler

1. Roof edge spoiler

¡

Material PUR-RIM

¡

Installation notes

66-8,

Installation notes

2. Route of primer surface on

spoiler

¡

Adhesive bead with a width of 3 mm
and a height of 5 mm

Special components of Golf "GTI 337 Edition"/Jetta GLI Sport and Golf R32

13/2/2005

3. Circumference of installed roof

edge spoiler

¡

Spoiler must be placed on rear lid
and circumference covered in tape

4. Primer surface/reside on rear lid

¡

Preparation

66-8, Preparing

bodywork for adhesive

¡

Dimension - a - = 7 mm

¡

Dimension - b - = 10 mm

Preparing bodywork for adhesive

Note:

Residual material acts as a base for new adhesive sealing
material. Keep adhesive surface free of dirt and grease.

Exception: If bonding is not performed immediately after
cutting back, remaining material must be activated using
Activator D 181 801 A1 .

Warning!

Activator must not come into contact with paint -
otherwise paint will be damaged.

Note:

If bodywork is being worked on or is partially replaced, it
must be cleaned and primed again after painting
corresponding area.

Installation notes

Surfaces of components to be primed must be free of dirt.

- Remove adhesive residue using Adhesive removal
solution D 002 000 10 .

- Saturate a cloth with Silicone remover LSE 020 100 A3 .

- Always wipe application area for adhesive bead twice
using saturated cloth and allow to air dry.

Special components of Golf "GTI 337 Edition"/Jetta GLI Sport and Golf R32

13/2/2005