Volkswagen Golf / Golf GTI / Jetta. Manual — part 176
01-246
Display group 62 - Speed control - Electronic Power Control system
Ignition on, engine not running
Read measured
value block 62
Indicated on display
xxx
%
xxx
%
xxx
%
xxx
%
1
2
3
4
Display zones
Specification Evaluation
Sender -2- for accelerator
pedal position -G185-
4...49 %
---
Throttle Position (TP) Sensor -
G79-
12...97 %
---
Throttle valve angle
Angle sensor -2- for throttle drive -G188-
100...0 %
---
Throttle valve angle
Angle sensor -1- for throttle drive -G187-
0...100 %
---
Note on display group 62:
The angle sensors for the Throttle Valve Control Module and the Throttle Position
(TP) sensor are featured in pairs for reasons of safety. The Motronic Engine Control
Module (ECM) -J220- constantly checks the plausibility of the potentiometers.
The value from Sender -2- for accelerator pedal position -G185- must display approx.
half the value of Throttle Position (TP) sensor 1 -G79- at all times.
The angle sensors for throttle drive are opposed. The values from both angle
sensors must always add up to approx. 100 %.
The specifications do not fully reach the max./min. figures.
Measured value (data) blocks
01-247
Display group 66 - Speed control - Additional signals
Engine running at idle
Read measured value
block 66
Indicated on
display
xxx
km/h
xxxxxxxx
xxx
km/h
xxxx
1
2
3
4
Display zones
Specification Evaluation
Switch position of
CCS controls switch
00000000
Page 01-
249
Specified vehicle speed
(last value stored by CCS)
---
---
Switch position from:
Clutch Vacuum Vent Valve
Switch -F36-
Brake Light Switch -F- and
Brake Vacuum Vent Valve
Switch -F47-
CCS controls switch
00001000
Page 01-
248
Vehicle speed (actual)
0 km/h
---
Note on display zone 2:
Check signal from Clutch Vacuum Vent Valve Switch -F36-
Page 24-199
.
Check signals from Brake Light Switch -F- and Brake Vacuum Vent Valve Switch -
F47-
Page 24-206
.
Note on display zone 4:
Check cruise control system (CCS)
Page 24-218
.
Measured value (data) blocks
01-248
Significance of figures in 8 digit number block, display zone 2 - Switch positions
Significance if display = 1
1 2 3 4 5 6 7 8
Significance
1 Brake depressed (Brake Light Switch -F-)
1
Brake depressed (Brake Vacuum Vent Valve Switch -F47-)
1
Clutch depressed (Clutch Vacuum Vent Valve Switch -F36-
)
1
Cruise control system operational
x
Not relevant
x
Not relevant
x
Not relevant
x
Not relevant
Note on 4th position in 8 digit number block:
If the cruise control system is not activated:
Electrical Wiring Diagrams, Troubleshooting & Component Locations
Measured value (data) blocks
01-249
Significance of figures in 8 digit number block, display zone 4 - CCS controls
switch
Significance if display = 1
1 2 3 4 5 6 7 8
Significance
0 CCS sliding switch at off (only with detent)
0
CCS sliding switch at off (not in detent or in detent)
1
SET button depressed
1
CCS sliding switch at RES
x
Not relevant
x
Not relevant
x
Not relevant
x
Not relevant
Function of cruise control regulating system:
Owner's Manual
Measured value (data) blocks
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст