Volkswagen Golf / Golf GTI / Jetta. Manual — part 174
01-238
Display group 54 - Speed control
While driving
Read measured value
block 54
Indicated on
display
xxxx
rpm
Text
xxx.x
%
xxx.x
%
1
2
3
4
Display zones
Specification Evaluation
Throttle valve angle
Angle sensor -1- for
throttle drive -G187-
0.0...100.0 %
---
Throttle valve angle
Throttle Position (TP) Sensor 1
-G79-
0.0...100.0 %
---
Operating condition
(idling, part throttle, enrichment,
overrun, wide open throttle)
---
---
Engine speed
640...2520
rpm
---
Note on display zone 1:
Above an engine speed of approx. 2520 rpm no indication will appear on display.
Note on display zone 2:
The operating condition is displayed according to engine speed or load. At a higher
engine speed, "overrun" is displayed when throttle valve is closed up to 1450 rpm only,
and then idle appears thereafter.
Note on display zone 3 and 4:
The specifications do not fully reach the max. min. figures.
Measured value (data) blocks
01-239
Display group 55 - Speed control - Idling stabilization
Engine running at idle
Read measured value
block 55
Indicated on
display
xxxx
rpm
xx.x
%
xx.x
%
xxxxx
1
2
3
4
Display zones
Specification
Evaluation
Operating
condition
xxxxx
Page 01-
240
Idling stabilization learning
value
-5.0...5.0 %
---
Idling control
-5.0...10.0 %
---
Engine speed (actual idle speed)
640...720 rpm
Page 01-
188
Note on display zone 1:
The rpm in display zone 1 (measured revolutions) is the actual engine speed.
Note on display zone 3:
Displayed is the amount that the idle speed stabilization has moved away from the
prescribed average. For a new engine the values lie in the positive range, because of the
higher friction and in the negative range with an engine that has run-in.
Measured value (data) blocks
01-240
Significance of figures in 5 digit number block, display zone 4 - Operating
conditions
Significance if display = 1
1 2 3 4 5
Significance
1 Air conditioner compressor switched on
1 Drive gear selected
1
Air conditioning system switched on
x
Not relevant
x
Not relevant
Measured value (data) blocks
01-241
Display group 56 - Speed control - Idling stabilization
Engine running at idle
Read measured value
block 56
Indicated on
display
xxxx
rpm
xxxx
rpm
xx.x
%
xxxxx
1
2
3
4
Display zones Specification
Evaluation
Operating
condition
xxxxx
Page 01-
240
Idling control
-5.0...10.0 %
---
Engine speed (specified idle
speed)
700 rpm
---
Engine speed (actual idle speed)
640...720 rpm
Page 01-
188
Notes on display zones 1 and 2:
The rpm in display zone 1 (measured revolutions) is the actual engine speed.
The rpm in display zone 2 (specified rpm) is theoretical engine speed calculated by
the Motronic Engine Control Module (ECM) -J220-. at idle, the Motronic Engine
Control Module (ECM) -J220- always tries to adapt the actual engine speed to the
specified engine speed.
Measured value (data) blocks
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст