Volkswagen Golf / Golf GTI / Jetta. Manual — part 936
80-20
2 - Self tapping
screw
Use if
retainer clips
break
3 - Air
distribution
housing
4
-
Servo motor for
fresh/recirculating
air door -V154-
Removing
and installing
Page 80
22
5 - Self tapping
screw
6 - Fresh air
blower -V2-
Removing
Page 80-7
,
Fig. 3
7 - Cover
8 - Self tapping
screw
9 - Series resistor
-N24-
Removing
Page 80-7
,
Fig. 3
10 - Sheet metal
screw
11 - Central flap
lever
Installing and
adjusting
Fig. 1
12 - Temperature
flap lever
13 - Base plate
Heating and ventilation system, servicing
13/2/2005
14 - Heater
core/bulkhead
seal
Installation
position
Fig. 2
Heating and ventilation system, servicing
13/2/2005
80-21
The central flap pinion has an
adjustment mark.
Fig. 1
Central flap lever,
installing and adjusting
- Install the lever so that the
notches on the lever and the
pinion align -arrows-.
The seal between the heater core
and the bulkhead has a positioning
mark.
Fig. 2
Heater core/bulkhead
seal, installation
position
- Install seal -1- so that the notches
on the seal and the base plate -2-
align -3-.
Heating and ventilation system, servicing
13/2/2005
80-22
Servo motor for
fresh/recirculating air door -V154-,
removing and installing
Removing
- Remove glove box.
Repair Manual, Body-Interior,
Repair Group 68
Installing
- Disconnect electrical connector -
1-.
- Remove screw -3-.
- Swing motor -2- downward.
- Disconnect motor -2- from fresh
air/recirculating air flap lever.
- Engage flap motor -2- with fresh
air/recirculating air lever.
- Position fresh air/recirculated air
flap lever by hand depending on
position of flap motor.
- Install screw -3-.
Heating and ventilation system, servicing
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст