Volkswagen Golf / Golf GTI / Jetta. Manual — part 1105
90-8
Instrument cluster, removing and
installing
Removing
WARNING!
Special safety precautions apply to vehicles
equipped with airbags. Refer to Repair
Manual, Body-Interior, Airbag: CAUTIONS
and WARNINGS, Repair Group 69.
CAUTION!
Switch off all electrical consumers.
Switch ignition off and remove ignition
key.
Notes:
Removal of instrument cluster is possible
without removing the steering wheel. In the
following instructions, the steering wheel is
shown removed for ease of illustration only.
All: Observe "Notes on replacing instrument
cluster"
Page 90-1
From m.y 2000: "Notes on replacing instrument
cluster"
Page 90-4
.
If replacing a malfunctioning instrument cluster
with a new one, note odometer reading on
existing cluster prior to removal.
- Release steering wheel position lock, pull
steering wheel out completely and lock again in
lowest position.
- Release cover -1- from clips and place on
steering column switch -2- upper cover.
Instrument cluster
13/2/2005
90-9
Installing
- Remove screws -arrows-.
- Pull instrument cluster out slightly
and disconnect electrical
connections on rear.
- Separate wiring harness for blue
32-pin multi-pin connector from
retainer on rear of instrument
cluster (where applicable).
- Remove instrument cluster.
- Insert instrument cluster into
opening and reconnect electrical
connections.
- Secure wiring harness for blue
32-pin multi-pin connection to
retainer -arrow- on rear of
instrument cluster (where
applicable).
- Remaining installation in reverse
order of removal.
- Perform functional check of
instrument cluster.
Instrument cluster
13/2/2005
90-10
If replacing a malfunctioning instrument cluster,
and a function check shows no further
malfunctions, proceed as follows:
Through m.y. 1999
- Code instrument cluster
Repair Manual, Electrical Equipment On
Board Diagnostic (OBD), Repair Group 01.
- Adapt odometer reading.
Repair Manual, Electrical Equipment On
Board Diagnostic (OBD), Repair Group 01.
From m.y. 2000
- Perform necessary instrument cluster
adaptations and coding, including coding the
Data Bus On Board Diagnostic Interface -J533-
as per OBD program
VAS 5051 / 5052 Vehicle Diagnostic Testing
and Information System in mode "Guided Fault
Finding"
Page 90-6
.
Instrument cluster
13/2/2005
90-11
Instrument
cluster, rear
view
1 - 32 pin
multi-pin
connector
Green
Connector
assignments
through m.y.
1999
Page 90-14
Connector
assignments
from m.y.
2000
Page 90-18
2 - Warning
buzzer
Oil
pressure
warning
Lights
on
warning
Brake
system
malfunction
Brake
pad/lining
wear
warning
Ignition
key
warning
Seat
belt
warning
3 - 32 pin
multi-pin
connector
Instrument cluster
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст