Volkswagen Golf / Golf GTI / Jetta. Manual — part 1104
90-4
Additional information, instrument
clusters from m.y. 2000
Instrument clusters from m.y. 2000 are integrated
into the vehicle CAN Data Bus network (also be
known as "CAN-Bus" or "Data-Bus").
The Data Bus On Board Diagnostic Interface -
J533- (which is integrated into the instrument
cluster) enables data to be exchanged between
the vehicle CAN Data-Bus network and the Data
Link Connector (DLC) "K-wire".
The Data Bus On Board Diagnostic Interface -
J533- has specific On Board Diagnostic (OBD)
capabilities
Repair Manual, Electrical Equipment-On
Board Diagnostic (OBD), Repair Group 01
or
VAS 5051/5052 Vehicle Diagnostic Testing
and Information System in mode "Guided Fault
Finding"
Notes on replacing instrument cluster
In addition to the normal service procedure of
coding the instrument cluster and adapting the
odometer reading, the Data Bus On Board
Diagnostic Interface -J533- must also be
separately coded according to vehicle market
version and equipment level variables
From m.y. 2000:
VAS 5051/5052 Vehicle Diagnostic Testing
and Information System in mode "Guided Fault
Finding"
Instrument cluster
13/2/2005
90-5
Additional information:
Complaint/symptom based repairs ("Service
Fixes")
Technical Bulletins
Instrument cluster, On Board Diagnostic
(OBD)
Repair Manual, Electrical Equipment On
Board Diagnostic (OBD), Repair Group 01.
VAS 5051/5052 Vehicle Diagnostic Testing
and Information System in mode "Guided Fault
Finding"
Instrument cluster
13/2/2005
90-6
Instrument cluster from m.y.
2000, replacing
Note:
The following OBD program
procedure applies only to
Golf/Jetta/GTI from m.y. 2000 and is
performed in conjunction with
removal and replacement
Page
90-8
.
Special tools, testers and auxiliary
items needed
CAUTION!
Switch off all electrical
consumers.
VAS 5051 / 5052 , connecting
VAS 5051 / 5052 Vehicle
Diagnostic Testing and
Information System
Adapter cable VAS 5051/1 or
VAS 5051/3
- Engage parking brake.
- Automatic transmission: Selector
lever in "N" or "P" position.
- Manual transmission: Selector
lever in "Neutral"position.
- With ignition switched off, connect
VAS 5051 / 5052 with adapter
cable to Data Link Connector
(DLC) located under the
instrument panel, left.
- Switch on ignition
Instrument cluster
13/2/2005
90-7
- Select mode "Guided Fault Finding"
- Enter appropriate model, equipment and model
year information and press ">" to confirm.
After all Control Modules have been registered
and DTC memories checked,
- Select "Go to"
- Select "Function / Component Selection"
- Select "Body (Repair Group 01; 27; 50 to 97"
- Select "Electrical System (Repair Group 27; 90
to 97)
- Select "01-Systems capable of self-diagnosis"
- Select "Instrument panel" or "dash panel insert"
where indicated
- Select "Functions"
- Select "Replacing instrument cluster with
immobilizer 3.gen" or "Instrument cluster,
replacing" as applicable.
- Forward with "
" button
- Follow/perform selected OBD program steps as
prompted by tester.
Instrument cluster
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст