Volkswagen Golf / Golf GTI / Jetta. Manual — part 867
01-245
V.A.G 1551 display
Possible cause
Corrective action
01362
Close switch for tailgate/trunk
lid -F124
-2)
Short to
Ground
1)
Faulty wiring or
connectors
- Check wiring and
connectors using wiring
diagram
Lock operating
mechanism or lock
cylinder mechanical
components binding
- Check lock operating
components and make
serviceable
- Replace lock cylinder
- Read Measuring Value
Block; Display group
number 008
Page 01-
266
, display zone 2
01389
Open switch for tailgate/rear lid
-F124-
2)
Implausible
signal
Short to
Ground
1)
1)
DTC recorded if operated for longer than 5 minutes
2)
Unclip contact switch on lock cylinder housing (with small screwdriver). -F124-
=Contact switch in locking cylinder for tailgate/anti-theft alarm/central locking
Convenience system (vehicles with power windows), On Board Diagnostic (O...
13/2/2005
01-246
V.A.G 1551 display
Possible cause
Corrective action
01483
Activation of rear lid remote
unlocking
Undefined
switch position
Faulty wiring or
connectors
- Check wiring and
connectors using wiring
diagram
01484
Central locking key button, lock
Short to
Ground
1)
Faulty wiring or
connectors
- Check wiring and
connectors using wiring
diagram
01485
Central locking key button, unlock
Short to
Ground
1)
Faulty wiring or
connectors
- Check wiring and
connectors using wiring
diagram
1)
DTC recorded if operated for longer than 10 seconds
Convenience system (vehicles with power windows), On Board Diagnostic (O...
13/2/2005
01-247
Output Diagnostic Test Mode
(DTM), vehicles from 06.01 on
The components displayed in the Output
Diagnostic Test Mode (DTM) can differ
depending upon the equipment fitted to the
vehicle. For example on vehicles without
ATA there will be no step "1" as listed in the
table below.
The Output Diagnostic Test Mode (DTM)
activates the following components in the
stated sequence:
Step
Display in tester
Reaction
1
Interior light, reading lights
- Interior and reading lights are
activated
2
"Safe" LED driver's door
- "Safe" LED lights up
3
Instrument illumination
- Switch illumination in control
module active
4
Signal close sliding roof
- Sliding roof closes
1)
5
Turn signal lights activation (for anti-
theft alarm)
- Activated continuously (lights up
cont.)
6
Alarm horn (for anti-theft alarm)
- Horn sounds continuously
7
END
- Information: End of regular final
control test
1)
When performing Output Diagnostic Test Mode (DTM) "Signal close sliding roof", the
ignition and S-terminal must be inactive (no key in ignition/starter switch) and one of the
front doors must be open.
Convenience system (vehicles with power windows), On Board Diagnostic (O...
13/2/2005
01-248
Special tools, testers and auxiliary items
V.A.G 1551 Scan tool or V.A.G 1552 vehicle
system tester with V.A.G 1551/3 cable
V.A.G 1594 Adapter set
V.A.G 1527 LED test light
Wiring diagram
Work sequence
- Connecting scan tool
Page 01-3
, initiating On
Board Diagnostic (OBD)
Page 01-96
.
Rapid data transfer
HELP
Select function XX
Indicated on display:
- Operate scan tool taking into account the
information on the display:
- Input 03 for "Output Diagnostic Test Mode
(DTM)" function.
- Switch off ignition and remove ignition key from
ignition lock.
Convenience system (vehicles with power windows), On Board Diagnostic (O...
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст