Volkswagen Golf / Golf GTI / Jetta. Manual — part 349
01-58
ABS control module, coding
All functions which could previously be
performed with V.A.G 1551 can also be
performed with the tester VAS 5051.
Warning light for ABS -K47- and warning light
for brake system -K118- flash when control
module is coded with 00000. An entry is not set
in the DTC memory.
The ABS control module (w/EDL) -J104- must
be recoded if the vehicle relevant coding is not
displayed or the control module has been
replaced.
Coding is only possible after the workshop code
(WSC) has been entered into the V.A.G 1551
Scan Tool.
Test sequence
- Connect V.A.G 1551 Scan Tool and select
(address word 03) "Brake electronics" with
ignition switched on;
Page 01-23
- Establish which type of ABS hydraulic control
module is installed
Page 01-4
.
- Establish engine code.
ABS ITT Mk 20 IE On Board Diagnostic (OBD) program
01-59
Rapid data transfer
HELP
Select function XX
Indicated on display
- Input 07 for "Code control
module" and confirm with Q key.
Rapid data transfer
Q
07 - Code control module
Indicated on display
- Confirm input with Q key.
Coding control module
Q
Enter code number XXXXX
(0-32000)
Indicated on display
- Enter relevant code number for
this vehicle and confirm with Q
key.
Coding variations
Page 01-60
.
1J0 907 379 D ABS 20 IE CAN 0001
Coding 03604
WSC 00000
On the display the control module
identification and coding are
displayed, e.g.:
ABS ITT Mk 20 IE On Board Diagnostic (OBD) program
01-60
Coding table
Code
number
Engine
code
Variant
03504
AEG
ABS
13504
AEG
ABS/EDL
03504
AFP
ABS
13504
AFP
ABS/EDL
13204
AFP
ABS/EDL/ASR
03504
ALH
ABS
13504
ALH
ABS/EDL
13204
APH
ABS/EDL/ASR
ABS ITT Mk 20 IE On Board Diagnostic (OBD) program
01-61
Measured value block, reading
Note:
All functions which could previously be
performed with V.A.G 1551 can also be
performed with the tester VAS 5051.
The control module can transfer a
considerable amount of test data. This test
data delivers information on the operational
condition of the system and/or sensors
connected to it. In many cases the
transferred test data supports
troubleshooting and repair. The test data
has been summarized into single display
groups because all the information cannot
be evaluated at the same time. The
information can be selected via display
group numbers.
ABS ITT Mk 20 IE On Board Diagnostic (OBD) program
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст