Volkswagen Golf / Golf GTI / Jetta. Manual — part 348
01-54
V.A.G 1551 print-
out
Possible cause
Repair
01316
Brake control
module
No
communication
Open circuit, short circuit to
positive or Ground in data bus
wiring
- Check data bus wiring and
connection using wiring
diagram
- Perform electrical checks
Page 01-102
ABS ITT Mk 20 IE On Board Diagnostic (OBD) program
01-55
V.A.G 1551
print-out
Possible
cause
Repair
18256
Check Engine
Control Module
(ECM) memory
DTC in ECM
Repair Manual, Fuel Injection & Ignition, Repair
Group 01 for relevant engine code
- Check engine control module DTC memory
65535
Control module
faulty
ABS Control
Module (w/EDL)
-J104- faulty
Repair Manual, Brake System, Repair Group
45; Hydraulic unit, brake booster/brake master
cylinder - Assembly overview; Removing and
installing control module and hydraulic unit
- Replace ABS control module (w/EDL) -J104-
ABS ITT Mk 20 IE On Board Diagnostic (OBD) program
01-56
Diagnostic Trouble Code
(DTC) memory, erasing and
ending output
Note:
All functions which could previously
be performed with V.A.G 1551 can
also be performed with the tester
VAS 5051.
Test requirements:
DTC memory checked
Page
01-28
.
1. Erasing DTC memory
- Press
key.
Rapid data transfer
HELP
Select function XX
Indicated on display
- Press keys -0- and -5-; 05 enters
"Erase DTC memory" function.
Rapid data transfer
Q
05 - Erase DTC memory
Indicated on display
- Confirm entry with Q key
Rapid data transfer
DTC memory is erased!
Indicated on display
- Press
key.
Rapid data transfer
HELP
Select function XX
Indicated on display
ABS ITT Mk 20 IE On Board Diagnostic (OBD) program
01-57
Warning!
DTC memory was not interrogated.
Indicated on display
Note:
Adhere exactly to test sequence:
First check DTC memory, then erase
2. Ending output
- Press keys -0- and -6-, to end
output.
Rapid data transfer
Q
06 - End output
Indicated on display
- Confirm input with Q key.
Rapid data transfer
HELP
Select function XX
Indicated on display
ABS warning light -K47- and warning
light for brake system -K118- must
go out after approx. 2 seconds.
- Switch ignition off.
- Disconnect V.A.G 1551 Scan
Tool at Data Link Connector
(DLC).
- Switch ignition on.
ABS ITT Mk 20 IE On Board Diagnostic (OBD) program
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст