Volkswagen Golf / Golf GTI / Jetta. Manual — part 85
20-60
Leak Detection Pump (LDP) -
V144-, checking
Special tools and equipment
VAG 1526 A multimeter, Fluke
83 multimeter or equivalent
VAG 1594 Adapter set
Evaporative Emissions (EVAP) system
20-61
Test conditions
No DTCs may be stored in DTC memory:
Repair Manual, 2.8 Liter VR6 4V Fuel Injection
& Ignition, Engine Code(s): BDF, Repair Group
01
Checking activation
- Check activation of LDP -V144- via output
Diagnostic Test Mode (DTM):
Repair Manual, 2.8 Liter VR6 4V Fuel Injection
& Ignition, Engine Code(s): BDF, Repair Group
01
If activation is OK:
- Check resistance at LDP -V144-
Page 20-
62
.
Evaporative Emissions (EVAP) system
20-62
Checking resistance
- Remove rear right wheel housing
liner:
Repair Manual, Body Exterior,
Repair Group 66
- Disconnect 3-pin connector
(arrow) for Leak Detection Pump
(LDP) -V144-.
- Connect multimeter to measure
resistance between contacts 1
and 3 of LDP -V144- using
adapter cables from VAG 1594 A.
Specification: 640...720
- Connect multimeter to measure
resistance between contacts 2
and 3 of LDP -V144- using
adapter cables from VAG 1594 A.
Specification: 12.5...19.5
Evaporative Emissions (EVAP) system
20-63
If the specifications are not attained:
- Replace Leak Detection Pump (LDP) -V144-
Page 20-42
, item - 7 -.
- Check DTC memory:
Repair Manual, 2.8 Liter VR6 4V Fuel Injection
& Ignition, Engine Code(s): BDF, Repair Group
01
- Read readiness code:
Repair Manual, 2.8 Liter VR6 4V Fuel Injection
& Ignition, Engine Code(s): BDF, Repair Group
01
- Generate readiness code again if DTC memory
has been erased or engine control module
separated from permanent positive supply.
Repair Manual, 2.8 Liter VR6 4V Fuel Injection
& Ignition, Engine Code(s): BDF, Repair Group
01
Evaporative Emissions (EVAP) system
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст