Volkswagen Golf / Golf GTI / Jetta. Manual — part 84
20-56
Functional check
Test conditions
Coolant temperature must be at least 85
C,
display group 1, display zone 2.
Test sequence
- Connect V.A.G 1551 Scan Tool (or V.A.G 1552).
Start engine and select "Address word" 01 of
engine control module.
Repair Manual, 2.8 Liter VR6 4V Fuel Injection
& Ignition, Engine Code(s): BDF, Repair Group
01
Rapid data transfer
HELP
Select function XX
Indicated on display
- Press keys 0 and 4 for function "Initiate basic
setting" and confirm entry with Q key.
Basic setting
Input display group number XXX
Indicated on display
- Press keys 0, 0 and 1 for "Display group number
1" and confirm entry with Q key.
System in basic setting 1
1
2
3
4
Indicated on display (1...4
display zones)
Evaporative Emissions (EVAP) system
20-57
Only continue with the test when
The coolant temperature is
above 85 C -Display zone 2-
- Change to display group 70 as
follows:
- Press C key.
Basic setting
Input display group number XXX
Indicated on display
Note:
The engine must not be loaded
during this diagnosis, if this occurs
the diagnosis will be interrupted and
will not start again until the engine is
revved-up.
- Press keys 0, 7 and 0 for "Display
group number 70" and confirm
entry with Q key.
System in basic setting 70
1
2
3
4
Indicated on display (1...4
display
zones)
If the diagnosis is initiated by the
engine control module the display in
display zone 4 jumps from "Test
OFF" to "Test ON".
Note:
This process can take approx. 30
seconds.
Evaporative Emissions (EVAP) system
20-58
- Leave engine running at idling speed until
display zone 4 displays specification TBV OK.
Note:
TBV stands for tank breather valve (EVAP
canister purge regulator valve -N80-).
If "TBV OK" appears in display zone 4:
- Press
key.
- Press keys 0 and 6 for function "End output" and
confirm entry with Q key.
- Switch ignition off.
If "TBV n. OK" appears in display zone 4:
- Press
key.
- Check DTC memory:
Repair Manual, 2.8 Liter VR6 4V Fuel Injection
& Ignition, Engine Code(s): BDF, Repair Group
01
- Read readiness code:
Repair Manual, 2.8 Liter VR6 4V Fuel Injection
& Ignition, Engine Code(s): BDF, Repair Group
01
Evaporative Emissions (EVAP) system
20-59
- Generate readiness code again if DTC memory
has been erased or engine control module
separated from permanent positive supply.
Repair Manual, 2.8 Liter VR6 4V Fuel Injection
& Ignition, Engine Code(s): BDF, Repair Group
01
If no DTC is stored in DTC memory:
- Press keys 0 and 6 for function "End output" and
confirm entry with Q key.
- Switch ignition off.
- Check breather lines to EVAP canister (may be
kinked).
- Check EVAP system for leaks
Page 20-47
.
Evaporative Emissions (EVAP) system
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст