Volkswagen Golf / Golf GTI / Jetta. Manual — part 83
20-52
- Generate readiness code again if DTC memory
has been erased or engine control module
separated from permanent positive supply:
Repair Manual, 2.8 Liter VR6 4V Fuel Injection
& Ignition, Engine Code(s): BDF, Repair Group
01
If no DTC is stored in DTC memory:
- Press keys 0 and 6 for function "End output" and
confirm entry with Q key.
- Switch ignition off.
- Check that fuel tank cap is completely closed or
if seal is leaking, replace as necessary.
- Repeat functional check.
If fault is still present:
- Check that fuel delivery unit union nut is tight or
if seal is leaking replace as necessary,
Page
20-15
, Removing and installing fuel delivery
unit.
- Repeat functional check.
If fault is still present:
Evaporative Emissions (EVAP) system
20-53
- Remove rear right wheel housing liner:
Repair Manual, Body Exterior, Repair Group
66
- Check to see if pressure hose between LDP and
EVAP canister is leaking
Page 20-43
, item -
8 - and replace if necessary.
- Check lines and line connections between EVAP
canister and fuel tank flap unit or tank breather
valve for leaks
Page 20-44
, Assembly
overview of EVAP system.
- Repeat functional check.
If fault is still present:
- Remove EVAP canister and check for cracks
and leaks, replace if necessary
Page 20-41
,
Servicing components of EVAP system.
- Repeat functional check.
Evaporative Emissions (EVAP) system
20-54
EVAP canister purge regulator
valve -N80-, checking
In a no-current situation the solenoid
valve is closed.
Special tools and equipment
Note:
All functions which could previously
be performed with V.A.G 1551/1552
can also be performed with the new
tester VAS 5051.
Test conditions
V.A.G 1551 Scan Tool (or
vehicle system tester V.A.G
1552) with cable VAG 1551/3
The fuses must be OK.
Battery voltage must be at least
11.5 V.
All electrical consumers, e.g.
lights and rear window defroster
must be switched off.
If the vehicle is equipped with air
conditioning, this must be
switched off.
Evaporative Emissions (EVAP) system
20-55
Selector lever must be in position "P" or "N"
on models with an automatic transmission.
Fuel pump relay -J17- must be OK,
checking:
Electrical Wiring Diagrams, Troubleshooting &
Component Locations
No DTCs may be stored in DTC memory:
Repair Manual, 2.8 Liter VR6 4V Fuel Injection
& Ignition, Engine Code(s): BDF, Repair Group
01
Checking activation
- Check activation of EVAP canister purge
regulator valve -N80- via output Diagnostic Test
Mode (DTM):
Repair Manual, 2.8 Liter VR6 4V Fuel Injection
& Ignition, Engine Code(s): BDF, Repair Group
01
If activation is OK:
- Perform functional check
Page 20-56
.
Evaporative Emissions (EVAP) system
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст