Volkswagen Golf / Golf GTI / Jetta. Manual — part 236
24-198
If no malfunctions can be found in
the wiring:
- Connect VAG 1598/31 test box to
control module wiring harness.
Engine Control Module (ECM) -
J220- remains disconnected.
- Check wiring for open circuit
between test box sockets 40 and
41 and air conditioning system
referring to Electrical Wiring
Diagrams.
Wire resistance: max. 1.5
- Check function of air conditioning
system.
- Check DTC memory, repair
malfunctions if necessary and
then erase DTC memory
Page
01-23
.
- Read readiness code
Page 01-
146
. If DTC memory has been
erased or Motronic Engine
Control Module (ECM) -J220- was
disconnected from battery
positive (B+), readiness code
must be generated again
Page
01-149
.
Additional signals, checking
24-199
Signal from Clutch Vacuum
Vent Valve Switch -F36-,
checking
Special tools, materials and
equipment
Note:
All functions which could previously
be performed with VAG 1551/1552
can also be performed with the VAS
5051.
VAG 1551 Scan tool (or VAG
1552) with VAG 1551/3 adapter
cable
VAG 1526 or Fluke 83 Hand
multimeter or VAG 1715
multimeter
VAG 1594 Adapter set
VAG 1598/31 test box
Electrical Wiring Diagrams
Additional signals, checking
24-200
Test requirements
Test sequence
The fuses must be OK.
The battery voltage must be at
least 11.5 V.
All electrical accessories, e.g.
lights and rear window defroster
must be switched off.
If the vehicle is equipped with air
conditioning, this must be
switched off.
Selector lever must be in
position "P" or "N" on vehicles
with an automatic transmission.
- Connect VAG 1551 Scan tool (or
VAG 1552). Then switch ignition
on and select Motronic Engine
Control Module (ECM) -J220- with
"Address word" 01. ((VAG 1551
and Motronic Engine Control
Module (ECM) -J220-, connecting
and selecting
Page 01-12
).
Rapid data transfer
HELP
Select function XX
Indicated on display:
- Press buttons -0- and -8- for
function "Read measured value
(data) block" and confirm entry
with -Q- button.
Additional signals, checking
24-201
Read measured value block
Input display group number XXX
Indicated on display:
- Press buttons -0-, -6- and -6- for
"Display group number 66" and
confirm entry with -Q- button.
Read measured value block 66
1
2
3
4
Indicated on display: (1...4
display
zones)
If the specifications are not
obtained:
- Observe display in display zone 2
(6th digit from left).
Specification: xxxxx0xx
- Depress clutch pedal fully and
observe values in display zone 2.
Specification: xxxxx1xx
- Press
button.
- Press buttons -0- and -6- for
function "End output" and confirm
entry with -Q- button.
- Switch off ignition.
- Remove cover in footwell (driver's
side).
Additional signals, checking
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст