Volkswagen Golf / Golf GTI / Jetta. Manual — part 346
01-46
V.A.G
1551 print-
out
Possible cause
Repair
00290
Left rear
ABS wheel
speed
sensor -
G46-
Open circuit, short to positive or
Ground, or loose contact in
connections between left rear
ABS wheel speed sensor -G46-
and ABS Control Module
(w/EDL) -J104-
- Check wiring and connections
using wiring diagram
- Perform electrical checks
Page
01-102
Left rear ABS wheel speed
sensor windings -G46- faulty
Damaged rotor or left rear ABS
wheel speed sensor -G46-
Repair Manual, Brake System,
Repair Group 45; Removing and
installing parts of ABS system on
front and rear axles
- Check left rear ABS wheel speed
sensor -G46- and rotor for damage
- Replace rotor/left rear ABS wheel
speed sensor -G46-
If the malfunction occurs again:
ABS Control Module (w/EDL) -
J104- faulty
Repair Manual, Brake System,
Repair Group 45; Hydraulic unit,
brake booster/brake master cylinder
- Assembly overview; Removing
and installing control module and
hydraulic unit
- Replace ABS Control Module
(w/EDL) -J104-
ABS ITT Mk 20 IE On Board Diagnostic (OBD) program
01-47
V.A.G 1551
print-out
Possible cause
Repair
00290
Left rear ABS
wheel speed
Sensor -G46-
Signal outside
tolerances
1)
Open circuit, short to positive or
Ground, or loose contact in
connections between left rear
ABS wheel speed sensor -G46-
and ABS Control Module (w/EDL)
-J104-
- Check wiring and
connections using wiring
diagram
- Perform electrical checks
Page 01-102
Electrical interference from other
sources (high frequency radiation
e.g. non-insulated ignition cable)
- Read measured value
block
Page 01-61
Display group number 001
Damaged rotor or left rear ABS
wheel speed sensor -G46-
Excessive air gap between left
rear ABS wheel speed sensor -
G46- and rotor (signal not OK.)
Repair Manual, Brake
System, Repair Group 45;
Removing and installing
parts of ABS system on front
and rear axles
- Check left rear ABS wheel
speed sensor -G46- and
rotor for damage
- Replace rotor/speed
sensor
1)
Type of DTC; this DTC is only recognized above 20 km/h (13 mph) (carry out test
drive).
ABS ITT Mk 20 IE On Board Diagnostic (OBD) program
01-48
V.A.G 1551
print-out
Possible cause
Repair
00290
Left rear ABS
wheel speed
sensor -G46-
Mechanical
malfunction
1)
Excessive air gap
between left rear ABS
wheel speed sensor -
G46- and rotor (signal
not OK.)
Repair Manual, Brake System,
Repair Group 45; Removing and
installing parts of ABS system on front
and rear axles
- Check installation of left rear ABS
wheel speed sensor -G46- and rotor
- Read measured value block
Page
01-61
Display group number 002
- Perform output Diagnostic Test
Mode (DTM)
Page 01-74
If the malfunction occurs again:
Outlet valve in ABS
hydraulic unit -N55-
faulty
Repair Manual, Brake System,
Repair Group 45; Hydraulic unit, brake
booster/brake master cylinder -
Assembly overview; Removing and
installing control module and hydraulic
unit
- Replace ABS hydraulic unit -N55-
1)
Type of DTC; this DTC is only recognized above 20 km/h (13 mph) (carry out test
drive).
ABS ITT Mk 20 IE On Board Diagnostic (OBD) program
01-49
V.A.G 1551 print-
out
Possible cause
Repair
00668
Vehicle voltage
terminal 30
Signal outside
tolerances
Open circuit, short to
positive or Ground in the
wiring
- Check wiring and connections
using wiring diagram
- Perform electrical checks
Page 01-102
01044
Control module
incorrectly coded
ABS Control Module
(w/EDL) -J104- incorrectly
coded
Coding bridge in multi-pin
connector has open or short
circuit
- Check ABS Control Module
(w/EDL) -J104- coding
Page
01-58
- Check wiring and connections
using wiring diagram
- Perform electrical checks
Page 01-102
ABS ITT Mk 20 IE On Board Diagnostic (OBD) program
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст