Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 260
– Guide the release cable -3- with the grommet -2- into the cover
-1-.
– Install the grommet -2- into the cover -1-.
– Insert the cover -1- into the door -2- in direction of -arrow a-.
– Engage the cover -1- all around in direction of -arrow b-.
Note
Check the cover by running one's fingers along the edge.
– If equipped, install the wire on the cover -1-.
– Install the rear door trim panel. Refer to ⇒ Body Interior; Rep.
Gr. 70 ; Rear Door Trim Panels; Rear Door Trim Panel, Re‐
moving and Installing .
2.9
Catch, Removing and Installing
Special tools and workshop equipment required
♦ Torque Wrench 1331 5-50Nm - VAG1331-
♦ Cylinder Head Bolt Socket - 3410-
Note
The following describes removing and installing the left catch. The right side is identical.
Removing
– Remove the bolts -2- and the catch -1-.
Installing
– Position the striker pin -1- on the C-pillar and tighten the bolts
-2-.
– Adjust the catch. Refer to
⇒ “1.4 Catch, Adjusting”, page 151
Component
Tightening Specification
Striker pin to the body
20 Nm
2.10
Cap, Removing and Installing
Special tools and workshop equipment required
♦ Lock Cylinder Housing Assembly Tool - T10389-
Removing
– Remove the plugs -3-.
– Guide the Lock Cylinder Housing Assembly Tool - T10389-
approximately 44 mm behind the bracket locking hook -2-.
– Pull the Lock Cylinder Housing Assembly Tool - T10389- ap‐
proximately 5 mm toward the rear in direction of -arrow- until
the hook releases.
– Remove the door handle from the door.
– Remove the cap -1- from the bracket.
Installing
– Remove the door handle from the door.
– Push the cap -1- into the bracket.
– Guide a screwdriver with a flat blade -4- approximately 40 mm
until the bracket locking hook -3-.
– Push the cap -1- onto the door.
– Push in the screwdriver approximately 5 mm in direction of
-arrow-, until the hook locks.
– Mount the plug -3-.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст