Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 259
Tightening Specifications
2.6
Window Crank, Removing and Installing
Removing
– Push the spacer ring -2- in the direction of -arrow a- and re‐
move the window crank -1- from the mechanism in direction
of -arrow b-.
Installing
– Push in the spacer ring -2- and push the window crank -1- on
the mechanism.
The installation position of the window crank -1- runs vertically
upward when the door window is closed.
Deviation of the window cranks to each other may be maximum
6°.
2.7
Window Crank, Removing and Installing
Special tools and workshop equipment required
♦ Torque Wrench 1783 - 2-10Nm - VAG1783-
Note
The following describes the removal and installation of the left window crank mechanism. Removing and in‐
stalling the right window crank mechanism is identical.
Removing
– Removing window crank. Refer to
⇒ “2.6 Window Crank, Removing and Installing”, page 168
.
– Remove the rear door trim panel. Refer to ⇒ Body Interior;
Rep. Gr. 70 ; Rear Door Trim Panels; Rear Door Trim Panel,
Removing and Installing .
– Secure the door window with adhesive tape to prevent it from
falling down.
– Remove the bolts -2- (quantity: 3).
– Remove the window crank mechanism -1- from the cable reel
mounts -3-.
Installing
– Install the window crank mechanism -1- onto the window crank
mounts -3-. Gently move the door window up and down so that
the splines between the window crank mechanism and the
cable reel can mesh.
– Tighten the screws -2-.
Installation is performed in reverse order of the removal.
Tightening Specifications
2.8
Door Inner Cover, Removing and Instal‐
ling
Special tools and workshop equipment required
♦ Trim Removal Wedge - 3409-
Note
The following describes the removal and installation of the left cover. The right side is identical.
Removing
– Remove the rear door trim panel. Refer to ⇒ Body Interior;
Rep. Gr. 70 ; Rear Door Trim Panels; Rear Door Trim Panel,
Removing and Installing .
– If necessary, remove the wire from the cover -1-.
– Lift the cover -1- at the bottom in direction of -arrow a-.
– Remove the cover -1- forward out of the door in direction of
-arrow b-.
Note
If it is necessary for the following work steps, remove the release cable -3- with the grommet -2- from the cover
-1-. If equipped, disconnect the connector from the grommet.
Installing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст