Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 258
– Switch off the ignition and all electrical equipment. Remove
the ignition key.
– Disconnect the connector -3-.
– Remove the bolts -2- (quantity: 3).
– Remove the window regulator motor -1- from the cable reel
mounts -4-.
WARNING
The additional functions and pinch protection must be coded
when a new window regulator motor (door control module) is
installed.
Installing
– Install the window regulator motor -1- on the cable reel mounts
-4-. Gently move the door window up and down so that the
splines between the window regulator motor and the cable reel
can mesh.
– Tighten the screws -2-.
– Connect the connector -3-.
– A new window regulator motor must be coded. Refer to Vehi‐
cle Diagnostic Tester .
– The work procedure and notes on the one-touch up/down and
pinch protection can be found in ⇒ Maintenance ; Booklet
36.1 .
Installation is performed in reverse order of the removal.
Tightening Specifications
2.5
Window Regulator, Removing and In‐
stalling
Special tools and workshop equipment required
♦ Torque Wrench 1783 - 2-10Nm - VAG1783-
Note
The following describes the removal and installation of the left window regulator. Removing and installing the
right window regulator is identical.
Removing
– Remove the rear door trim panel. Refer to ⇒ Body Interior;
Rep. Gr. 70 ; Rear Door Trim Panels; Rear Door Trim Panel,
Removing and Installing .
– Loosen the door window from the window regulator, but do not
remove. Refer to
⇒ “5.5 Rear Door Window, Removing and Installing”,
– Push the door window upward and secure.
– Remove the window regulator motor or the window crank. Re‐
fer to
⇒ “2.4 Window Regulator Motor, Removing and Installing”,
⇒ “2.7 Window Crank, Removing and Installing”, page 168
– Release the hooks on the cable reel -3- and push into the door.
– Remove the lower hex nut -2- and push the window regulator
threaded pin in the door.
– Loosen the upper hex nuts -2-, but do not remove.
– Slide the window regulator in the door slightly upward in di‐
rection of -arrow a- and guide it into the door in direction of
-arrow b-.
– Turn the window regulator -4- 90° and remove it through the
opening in the door in direction of -arrow c-.
Installing
– Guide the window regulator -4- through the opening into the
door in direction of -arrow a- and bring it into the installation
position.
– Push the window regulator threaded pin through the inner door
panel in direction of -arrow b- and push downward in direction
of -arrow c-.
– Tighten the hex nuts -2-.
– Push the cable reel against the door inner panel -3- until the
hooks engage audibly.
– Install the window regulator motor or window crank mecha‐
nism. Refer to
⇒ “2.4 Window Regulator Motor, Removing and Installing”,
or
⇒ “2.7 Window Crank, Removing and Installing”, page 168
.
– Install the door window. Refer to
⇒ “5.5 Rear Door Window, Removing and Installing”,
.
– Install the rear door trim panel. Refer to ⇒ Body Interior; Rep.
Gr. 70 ; Rear Door Trim Panels; Rear Door Trim Panel, Re‐
moving and Installing .
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст