Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 289
– Install the tension wire -5- in the sun shade material -6-.
– Slide the tension bow -4- onto the sun shade material.
– Push the slider -2- with the tension spring -3- into the tension
bow.
Installation is performed in reverse order of the removal.
1.16.2
Sunroof Shade, Removing and Instal‐
ling, Sedan from 03/2015
Special tools and workshop equipment required
♦ Torque Wrench 1783 - 2-10Nm - VAG1783-
Caution
A visual inspection when the sliding sunroof is open on the
vehicle is essential to order the correct replacement part. Refer
⇒ “1.1 Characteristics - Sliding Sunroof, Sedan”, page 193
Removing
– Remove the glass panel. Refer to
⇒ “1.6 Glass Panel, Removing and Installing”, page 223
– Remove the bolts -3- for the shade cover -1-.
– Lift up the cover -1- and remove from the slotted guide rail
guide mounting points -2- -arrows-.
– Remove the tension bow. Refer to
Note
♦
If the sun shade is reused, make sure that the steel bands are
not bent.
♦
If a steel band is bent, then a new sun shade must be installed.
– Disconnect the steel-band carrier -3- from the slider lower
section -2- using a flat-head screwdriver.
– Remove the bolt -3- and remove the rear stop buffer -2-.
– Open the sun shade carefully.
– Remove the clip -3- -arrow A-.
– Remove the sun shade -1- from the slotted guide rail guide
-2- on the right side -arrow B-.
– Remove the sun shade -1- carefully from the slotted guide rail
guide -2- on the left side -arrow-.
– Move the sun shade -1- evenly toward the rear in order to pull
the material with the steel bands out of the guide rails.
– Remove the sun shade -1- from the sunroof frame.
Installing
Note
♦
When installing the sun shade, make sure that the steel bands
are not bent.
♦
If a steel band is bent, then a new sun shade must be installed.
– Install the right and left catches into the guide rails.
– Carefully slide the material with steel bands slightly and evenly
toward the front.
– First lift the sun shade carefully into the slotted guide rail guide
on the left side then the right and secure with the clip.
Note
♦
Make sure the catch is positioned correctly in the guide rails.
♦
Make sure the O-rings are in the correct position.
– Push the slider lower section -2- back and secure with the
catches -3-.
– Mount the rear stop buffer and secure with the bolt -3-.
– Install the tension bow. Refer to
.
– Mount the slotted guide rail guide cover.
– Install the glass panel. Refer to
⇒ “1.6 Glass Panel, Removing and Installing”, page 223
Tightening Specifications
♦ Refer to
⇒ “1.3.2 Overview - Sunroof Shade, Sedan from 03/2015”,
Tension Bow, Removing and Installing
Removing
– Remove the bolt -1-.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст