Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 287
– Remove the glass panel. Refer to
⇒ “1.6 Glass Panel, Removing and Installing”, page 223
.
– Remove the glass panel if the drive motor is defective. Refer
to
⇒ “1.6.3 Glass Panel, Removing, Defective Drive Motor, Se‐
dan through 02/2015”, page 232
.
– Remove the self-adhesive insulation -3-.
– Remove the bolts -2-.
– Remove the cover -1- upward at an angle in direction of
-arrows-.
– Remove the screws -3- and then remove the handle -4-.
– Remove the screws -5-.
Note
♦
If the sun shade is reused, make sure that the steel bands are not bent.
♦
If a steel band is bent, then a new sun shade must be installed.
– Lift the sun shade -1- left and right at the rear in direction of
-arrow a- and push evenly rearward in direction of -arrow b-,
the pull from the guide rails -2-.
– Push the slider -3- into the bow in direction of -arrow c- and
remove it from the guide in direction of -arrow d-.
– Remove the sun shade -1- from the sunroof frame.
When it is necessary for further work, the tension bow can be
removed from the sun shade. Refer to
Installing
Note
♦
When installing the sun shade, make sure that the steel bands are not bent.
♦
If a steel band is bent, then a new sun shade must be installed.
– Install the right and left yoke -2- into the guide rails -3- in di‐
rection of -arrow a-.
– Make sure the upper in direction of -arrow b- and lower in di‐
rection of -arrow c- yokes are positioned correctly on the guide
rail.
– Push the slider -2- in the guide in direction of -a arrows-.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст