Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 290
– Lift up the bow -3- with the slider upper section -2-.
– Remove the slider upper section in the direction of the
-arrow-.
– Lift up the bow -3- -arrow B-.
– Remove the tension bow from the sunroof shade material -1-
-arrow A-.
– The tension wire -2- stays in the sun shade material -1- during
this.
Installing
– Slide the tension wire -2- into the sun shade material -1-.
– Slide the tension bow -3- onto the sun shade material.
– Slide the slider upper section into the tension bow and bolt it
to the slider lower section.
Tightening Specifications
♦ Refer to
⇒ “1.3.2 Overview - Sunroof Shade, Sedan from 03/2015”,
1.16.3
Sunroof Shade, Removing and Instal‐
ling, Wagon
Special tools and workshop equipment required
♦ Torque Wrench 1783 - 2-10Nm - VAG1783-
Note
♦
Using a commercially available hex socket head wrench, rotate shade motor into open direction to removal
position if the electrical system malfunctions.
♦
Ensure cleanliness when working on the sun shade material, parts may need to be covered. Wear gloves
if necessary.
Removing
– Move the sun shade to the fully open position.
– Remove the front glass panel. Refer to
⇒ “1.6.4 Glass Panel, Removing and Installing, Wagon”, page
– Remove the rear glass panel. Refer to
⇒ “1.7 Rear Sunroof Panel, Removing and Installing”,
.
– Remove the sunroof frame. Refer to
⇒ “1.4.2 Sunroof Frame, Removing and Installing, Wagon”,
.
– Press down the locking mechanism -3- in direction of
-arrow A-.
– Slide the bow -4- all the way to the side in direction of
-arrow B-.
– On the opposite side, slide the bow -4- toward the rear from
the sun shade glide -2- in direction of -arrow C-.
– If needed, remove the bow -4- completely from the sun shade
-1- to the side in direction of -arrow D-.
Note
In the following steps, make sure that the sun shade material is not damaged.
– Using a flat-head screwdriver, carefully lift the hook at the sun
shade glide.
– Remove the sun shade with the sun shade glide out of the
guide toward the rear.
– Repeat the work steps on the opposite side.
– Remove the bolts -3-.
– Release the hook using a flat-head screwdriver -5- in direction
of -arrow a-.
– Slide the entire sun shade -1- with the left and right shade
mounts -2- out of the sunroof frame toward the rear in direction
of -arrow D- and upward in direction of -arrow E-.
– Lift the entire sun shade with the shade mounts out of the
sunroof frame in direction of -arrow B-.
Installing
Note
Do not lubricate the sun shade slide and cables.
– Insert the sun shade -1- complete with the left and right shade
frames -2- into the sunroof frame.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст