Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 941
4 - Access/Start System Interface - J965-
❑ Bracket screws (only for NAR): 2 Nm
❑ Removing and installing. Refer to
⇒ “7.3 Access/Start System Interface J965 , Removing and Installing”, page 170
7.2.2
Component Location Overview - Rear Keyless Access Authorization Sys‐
tem, Sedan
1 - Access/Start System An‐
tenna In Luggage Compart‐
ment - R137-
❑ Removing and instal‐
ling. Refer to
.
2 - Access/Start System Inter‐
face - J965-
❑ Bracket screws (only for
NAR): 2 Nm
❑ Removing and instal‐
ling. Refer to
.
3 - Access/Start System An‐
tenna in Rear Bumper - R136-
❑ Removing and instal‐
ling. Refer to
7.2.3
Component Location Overview - Rear Keyless Access Authorization Sys‐
tem, Wagon
1 - Access/Start System An‐
tenna in Rear Bumper - R136-
❑ Removing and instal‐
ling. Refer to
.
2 - Access/Start System An‐
tenna In Luggage Compart‐
ment - R137-
❑ Removing and instal‐
ling. Refer to
3 - Access/Start System Inter‐
face - J965-
❑ Bracket screws (only for
NAR): 2 Nm
❑ Removing and instal‐
ling. Refer to
7.3
Access/Start System Interface - J965- ,
Removing and Installing
⇒ “7.3.2 Access/Start System Interface J965 , Removing and
7.3.1
Access/Start System Interface - J965- ,
Removing and Installing, Except North
America
If the control module is being replaced, use the Vehicle Diagnostic
Tester and select the “Replacing” function for the respective con‐
trol module in “Guided Fault Finding”.
Removing
– Turn off the ignition and all electrical equipment.
– Remove the ignition key, if equipped.
– Remove the footwell cover on the driver side. Refer to ⇒ Body
Interior; Rep. Gr. 68 ; Storage Compartments and Covers;
Driver Side Footwell Cover, Removing and Installing .
– Remove the knee airbag with igniter. Refer to ⇒ Body Interior;
Rep. Gr. 69 ; Knee Airbags; Overview - Knee Airbag .
– Push the bracket -2- upward in the direction of the -arrow A-
from the Access/Start System Interface - J965- -1-.
– Remove the Access/Start System Interface - J965- -1- in the
direction of the -arrow B- from the bracket -2-.
– Disconnect the connector -3-.
– To disconnect push the circlip -1- on the connector.
– Pivot the retaining bracket in the direction of -arrow- and re‐
move from the connector.
– Pry up the catch -1- using a small screwdriver in the direction
of the -arrow A- if necessary.
– Remove the bracket -2- in the direction of the -arrow B- from
the brace -3-.
Installing
Install in the reverse order of removal while paying attention to
the following:
– The bracket for the Access/Start System Interface - J965-
must engage audibly.
– The Access/Start System Interface - J965- must engage au‐
dibly in the bracket.
7.3.2
Access/Start System Interface - J965- ,
Removing and Installing
If the control module is being replaced, use the Vehicle Diagnostic
Tester and select the “Replacing” function for the respective con‐
trol module in “Guided Fault Finding”.
Removing
– Turn off the ignition and all electrical equipment.
– Remove the ignition key, if equipped.
– Remove the glove compartment. Refer to ⇒ Body Interior;
Rep. Gr. 68 ; Storage Compartments and Covers; Glove
Compartment, Removing and Installing .
– Push the bracket -3- rearward in the direction of the
-arrow A- from the Access/Start System Interface - J965- -1-.
– Remove the Access/Start System Interface - J965- -1- in the
direction of the -arrow B- from the bracket -3-.
– Release and disconnect the connector -2-.
– To disconnect the connector press the circlip -1-.
– Pivot the retaining bracket in the direction of -arrow- and re‐
move from the connector.
– Remove the bolts -arrows- from the bracket -1-.
– Remove the bracket -1- from the heater and A/C unit.
Installing
Install in the reverse order of removal while paying attention to
the following:
– The Access/Start System Interface - J965- must engage au‐
dibly in the bracket.
Tightening Specifications
♦ Refer to
⇒ “7.1 Component Location Overview - Access/Start Authori‐
7.4
Driver Exterior and Front Passenger Ex‐
terior Door Handle Touch Sensor -
G415- / -G416- , Removing and Instal‐
ling
The Driver Exterior Door Handle Touch Sensor - G415- and the
Front Passenger Exterior Door Handle Touch Sensor - G416- is
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст