Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 942
integrated in the exterior door handle and cannot be replaced in‐
dividually if faulty.
– Door handle removing and installing. Refer to ⇒ Body Exterior;
Rep. Gr. 57 ; Door Components; Door Handle, Removing and
Installing .
7.5
Access/Start System Antenna 1 in Ve‐
hicle Interior - R138- , Removing and
Installing
Special tools and workshop equipment required
♦ Pry Lever - 80-200-
Removing
– Turn off the ignition and all electrical equipment.
– Remove the ignition key, if equipped.
– Remove the center console insert. Refer to ⇒ Body Interior;
Rep. Gr. 68 ; Center Console; Center Console Insert, Re‐
moving and Installing .
– Pry the Access/Start System Antenna 1 in Vehicle Interior -
R138- -1- using the -80-200- from the bracket -3-.
– Release and disconnect the connector -2-.
Installing
Install in reverse order of removal.
7.6
Driver Access/Start System Antenna -
R134- , Removing and Installing
The Driver Access/Start System Antenna - R134- is integrated
into the exterior door handle and cannot be replaces separately
if faulty.
– Door handle removing and installing. Refer to ⇒ Body Exterior;
Rep. Gr. 57 ; Door Components; Door Handle, Removing and
Installing .
7.7
Front Passenger Access/Start System
Antenna - R135- , Removing and Instal‐
ling
The Front Passenger Access/Start System Antenna - R135- is
integrated into the exterior door handle and cannot be replaces
separately if faulty.
– Door handle removing and installing. Refer to ⇒ Body Exterior;
Rep. Gr. 57 ; Door Components; Door Handle, Removing and
Installing .
7.8
Access/Start System Antenna in Lug‐
gage Compartment - R137- , Removing
and Installing
⇒ “7.8.1 Access/Start System Antenna in Luggage Compartment
R137 , Removing and Installing, Wagon”, page 174
7.8.1
Access/Start System Antenna in Lug‐
gage Compartment - R137- , Removing
and Installing, Sedan
Special tools and workshop equipment required
♦ Pry Lever - 80-200-
Removing
– Turn off the ignition and all electrical equipment.
– Remove the ignition key, if equipped.
– Remove the rear bench seat. Refer to ⇒ Body Interior; Rep.
Gr. 72 ; Rear Seats; Bench Seat/Single Seat, Removing and
Installing .
– Fold back the carpet.
– Pry the Access/Start System Antenna in Luggage Compart‐
ment - R137- -1- using the -80-200- in the direction of the
-arrow A- from the body.
– Release and disconnect the connector -2-.
Installing
Install in reverse order of removal.
7.8.2
Access/Start System Antenna in Lug‐
gage Compartment - R137- , Removing
and Installing, Wagon
Special tools and workshop equipment required
♦ Pry Lever - 80-200-
Removing
– Remove the luggage compartment floor covering. Refer to ⇒
Rep. Gr. 70 ; Luggage Compartment Trim Panels; Overview
- Luggage Compartment Floor .
– Pry out the antenna -1- with the -80-200- in the direction of the
-arrow A- from the body.
– Disconnect the connector -2-.
Installing
Install in reverse order of removal.
7.9
Access/Start System Antenna in Rear
Bumper - R136- , Removing and Instal‐
ling
Removing
– Turn off the ignition and all electrical equipment.
– Remove the ignition key, if equipped.
– Remove the rear bumper cover. Refer to ⇒ Body Exterior;
Rep. Gr. 63 ; Rear Bumper; Bumper Cover, Removing and
Installing .
– Pry the Access/Start System Antenna in Rear Bumper - R136-
-1- slightly in the direction of the -arrow A-.
– Remove the Access/Start System Antenna in Rear Bumper -
R136- -1- in the direction of the -arrow B- from the mount -3-.
– Release and disconnect the connector -2-.
Installing
Install in reverse order of removal.
8
Steering Column Switch Module
⇒ “8.1 Overview - Steering Column Switch Module”, page 176
⇒ “8.2 Lock Cylinder, Removing and Installing”, page 179
⇒ “8.3 Ignition Switch Key Lock Solenoid N376 , Removing and
Installing”, page 180
⇒ “8.4 Ignition/Starter Switch, Removing and Installing”,
page 181
⇒ “8.5 Steering Column Switch Module, Removing and Installing”,
page 182
⇒ “8.6 Steering Column Electronics Control Module J527 , Re‐
moving and Installing”, page 187
⇒ “8.7 Turn Signal Switch E2 , Removing and Installing”,
page 192
⇒ “8.8 Cruise Control Switch E45 , Removing and Installing”,
page 194
⇒ “8.9 Windshield Wiper Intermittent Mode Switch E22 , Remov‐
ing and Installing”, page 194
⇒ “8.10 Anti-Theft Immobilizer Reader Coil D2 , Removing and
Installing”, page 194
⇒ “8.11 Steering Lock Housing, Removing and Installing”,
8.1
Overview - Steering Column Switch
Module
⇒ “8.1.1 Overview - Steering Column Switch Module with Me‐
chanical Ignition Switch”, page 176
⇒ “8.1.2 Overview - Steering Column Switch Module and Elec‐
tronic Ignition Switch”, page 178
8.1.1
Overview - Steering Column Switch Module with Mechanical Ignition Switch
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст