Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 570
Checking the Metal Ring
– Check the metal ring in the clutch pressure plate -arrow- for
damage.
• Replace any clutch pressure plates that have a broken metal
ring.
– Use the Alignment Tool - Clutch Plate - 3190A- to center the
clutch plate.
– Tighten the bolt diagonally in small steps.
– Install the transmission. Refer to
⇒ “2.2 Transmission, Installing”, page 77
.
Tightening Specifications
♦ Pressure plate on the flywheel. Refer to
3
Special Tools
Special tools and workshop
equipment required
♦ Flywheel Retainer - 3067-
♦ Alignment Tool - Clutch
Plate - 3190A-
♦ Torque Wrench 1331
5-50Nm - VAG1331-
♦ Grease for Clutch Disc
Shaft Splines - G 000 100-
♦ Sealing Tool - T10249-
♦ Brake Charger/Bleeder Unit - VAG1869-
♦ Brake Charger/Bleeder Unit - VAS5234- or
♦ Hose Clamps - Up To 25 mm - 3094-
34 – Controls, Housing
1
Selector Mechanism
⇒ “1.1 Selector Mechanism Installation Position”, page 51
⇒ “1.3 Overview - Selector Mechanism”, page 53
⇒ “1.2 Overview - Gearshift Knob and Cover”, page 52
⇒ “1.4 Gearshift Knob, Removing and Installing”, page 54
⇒ “1.5 Selector Mechanism, Removing and Installing”,
page 56
⇒ “1.6 Selector Mechanism, Adjusting”, page 63
⇒ “1.7 Selector Mechanism, Checking”, page 65
⇒ “1.8 Selector Shaft Seal, Replacing”, page 65
1.1
Selector Mechanism Installation Position
-Arrow A- Gearshift Lever Movement
-Arrow B- Selector Lever Movement
A - Gearshift Lever Cable
B - Selector Cable
C - Heat Shield
❑ Remove the shift mech‐
anism before removal.
1 - Gearshift Lever
2 - Selector Relay Lever
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст