Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 291
– Insert the sun shade -1- complete with the left and right shade
frames -2- into the sunroof frame.
– Slide the shade frames into the guides and lock.
– Tighten the bolts -3-.
Installation is performed in reverse order of the removal.
Note
Check for ease of movement after installing the sun shade. Using a commercially available hex wrench, man‐
ually turn the sun shade drive on the motor and make sure there are not creases or folds in the sun shade
material.
– After completing the work procedure, perform an adaptation
on the sun shade motor. Refer to
⇒ “1.18 Roof Shade Control Module J394 , Programming”,
.
Tightening Specifications
1.17
Power Sunroof Control Module - J245- ,
Programming
Power Sunroof Control Module - J245- , Putting into Operation.
Refer to
Sunroof Motor - V1- , Programming
Note
♦
After installing the Sunroof Motor - V1- , a programming pro‐
cedure must be performed
♦
Risk of damaging sunroof components by moving the slotted
guide rail guide.
♦
Only move the slotted guide rail guide with the glass panel
installed
– Connect the Vehicle Diagnostic Tester .
– Switch the ignition on.
– Select and start
Diagnosis
mode
– Select the
Test plan
tab.
– Select the “Select individual text” button and the subsequent
tree structure.
• Body
• Body, Assembly
• 01 – OBD-Capable Systems
• CA – Power Sunroof Control Module J245
• CA - Power Sunroof Control Module J245, Functions
• CA – Basic setting
• CA – J245 Sunroof, no basic setting
– Start the selected program and follow the instructions on the
Vehicle Diagnostic Tester display.
Power Sunroof Control Module - J245- , Putting into Operation
If the Power Sunroof Control Module - J245- was replaced, it must
be put into operation after installation.
– Connect the Vehicle Diagnostic Tester .
– Switch the ignition on.
– Select and start
Diagnosis
mode
– Select the
Test plan
tab.
1.18
Roof Shade Control Module - J394- ,
Programming
Note
♦
After a glass panel, a motor, or the tilting mechanism was re‐
placed, an adaptation must be performed.
♦
Pinch protection is switched off when performing an adapta‐
tion.
The ignition is switched on.
– Press the “close” button while holding in this position for the
entire adaptation process (approximately 20 seconds).
The sunroof shade closes completely.
1.19
Operating without Electricity
⇒ “1.19.1 Operating without Electricity, Sedan through 02/2015”,
page 299
⇒ “1.19.2 Operating without Electricity, Wagon”, page 300
1.19.1
Operating without Electricity, Sedan through 02/2015
Note
If there is a malfunction in the electrical system, the sunroof with the glass panel can be moved at the drive
motor using a commercially available hex wrench.
Removing
– Remove the glass panel if the drive motor is defective. Refer
to
⇒ “1.6.3 Glass Panel, Removing, Defective Drive Motor, Se‐
dan through 02/2015”, page 232
– Remove the self-adhesive insulation -3-.
– Remove the bolts -2-.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст