Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 517
Removing the Needle Sleeve from the Clutch Housing
A - Counter Support , for example, -22/2-
B - Internal Puller 23.5 to 30 mm , for example -21/4-
Note
The needle sleeve will get damaged when it is removed and must
be replaced.
Installing the Needle Sleeve -A- into the Clutch Housing
– Lay the reverse shaft thrust washer -B- on the needle sleeve
while pressing it in.
7
Securing on Engine and Transmis‐
sion Holder
⇒ “7.1 Securing on Engine and Transmission Holder”,
7.1
Securing on Engine and Transmission
Holder
Special tools and workshop equipment required
♦ Holding Plate - VW309A-
♦ Transmission Support - VW353-
♦ Drip Tray for VAG1202A - VAG1306-
Procedure
– Secure the transmission with the -VW353- to the -VW309-
-arrows-.
Note
If one of the fastening holes does not touch the Transmission
Support , place washers between the fastening hole and the
Transmission Support .
– Insert the - VW309- in the -VAS6095A- .
8
Transmission Fluid
⇒ “8.1 Transmission Fluid Level, Checking”, page 142
8.1
Transmission Fluid Level, Checking
Special tools and workshop equipment required
♦ For oil filler plug with multi-point fitting Triple Square Socket
Driver - 3357- .
♦ Torque Wrench 1331 5-50Nm - VAG1331-
♦ Used Oil Collection and Extraction Unit - SMN372500-
Transmission fluid specification. Refer to the Parts Catalog.
– Remove the noise insulation. Refer to ⇒ Body Exterior; Rep.
Gr. 66 ; Noise Insulation; Overview - Noise Insulation .
– Place the -SMN372500- under the transmission.
– Remove the plug for checking the transmission fluid level
-arrow-.
The level is correct when the transmission fluid comes up to the
bottom edge of oil filler hole.
– Add transmission fluid, if necessary, until it reaches the lower
edge of the filler hole.
– If present with new seal, install bolt -arrow-.
– Tighten the bolt -arrow-
⇒ Fig. ““Different Versions of Fluid Fill and Drain Plugs”“ , page
.
Different Versions of Fluid Fill and Drain Plugs
I - Fluid fill or drain plug with internal multi-point: 45 Nm
II - Fluid fill or drain plug with inner hex socket: 30 Nm
– Install the noise insulation. Refer to ⇒ Body Exterior; Rep. Gr.
66 ; Noise Insulation; Overview - Noise Insulation .
9
Special Tools
♦ Slide Hammer Set - Adapt‐
er 40 - VW771/40-
♦ Engine Support Brackets -
T40093/3-6- (quantity 2)
♦ Engine Support Bridge -
Special Hook (2 pc.) -
10-222A/20-
♦ Engine Support - Basic Set
- Square Pipe - T40091/1-
(quantity 2)
♦ Engine Support - Basic Set
- Movable Joint - T40091/3-
(quantity 2)
♦ Engine Support - Supple‐
ment Kit - Spindle -
T40093/3- (quantity 2) from
the Engine Support - Sup‐
plement Kit - T40093A-
♦ Engine Sling - Engine
Bracket - 2024A/1- from
Engine Sling - 2024A-
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст