Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 393
– Slide the instrument panel -1- into the mounts -2- in the wind‐
shield transition area -arrow A-.
– Insert the left and right guide tabs into the guide holes
-arrow B-.
Tightening Specifications
♦ Refer to
⇒ “3.1 Overview - Instrument Panel”, page 210
3.7
Instrument Panel Vent, Removing and
Installing
Special tools and workshop equipment required
♦ Backrest Panel Tool - 3370-
♦ Trim Removal Wedge - 3409-
Removing
Side Instrument Panel Vent
Note
The removal and installation for the side instrument panel vent on
the driver side is described. The removal and installation for the
front passenger side is identical.
– Completely open the side instrument panel vent -1- using the
thumbwheel.
– Carefully guide the Backrest Panel Tool - 3370- -2- into the
center of the second slat from above and hook it in to the rear
of the vent -1-.
Note
The insertion depth of the Backrest Panel Tool - 3370- is 115 mm.
– Pull the side instrument panel vent out of the instrument panel
installation opening with a firm jerk.
Center Vent with Front Information Display Control Head - J685-
trim
Note
The center vent is removed together with the Front Information
Display Control Head - J685- trim.
Caution
The Front Information Display Control Head - J685- trim cannot
be removed as an individual part without being destroyed.
• Center vent is completely open at both thumbwheels.
• The vertical slats of the center vent are positioned in the di‐
rection of travel.
– Remove the display and control head trim. Refer to
⇒ “3.5 Display and Control Unit Trim, Removing and Instal‐
.
– Grab the Front Passenger Airbag -Disabled- Indicator Lamp -
K145- -1- at the side -arrows A- and pull it out of the instrument
panel.
– Disconnect the connectors.
– Carefully guide a Backrest Panel Tool - 3370- in both the right
and left center vent -arrows-.
– Hook both Backrest Panel Tools - 3370- into the top end of the
corresponding fresh air duct.
Note
The insertion depth of the Backrest Panel Tool - 3370- is approximately 110 mm.
– Remove the center vent -1- including the installed trim -2- from
the instrument panel installation opening at the same time by
firmly tugging on the two Backrest Panel Tools - 3370- .
– Carefully unclip the trim -2- from the mounts in the instrument
panel -arrows- using the Trim Removal Wedge - 3409- .
Installing
Note
Check all the fasteners for damage and replace if necessary.
Install in reverse order of removal.
3.8
Side Defroster Vent, Removing and In‐
stalling
Note
The removal and installation for the side defroster vent on the
driver side is described. The removal and installation for the front
passenger side is identical.
Special tools and workshop equipment required
♦ Trim Removal Wedge - 3409-
Removing
– Pry the defroster vent -1- upward out of the instrument panel
installation opening using the Trim Removal Wedge - 3409-
and remove it.
Installing
Install in reverse order of removal.
3.9
Front Passenger Side Impact Absorber, Removing and Installing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст