Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 279
– Lower the guide rails -1- at the rear -arrow a-.
– Remove the guide rails -1- from the sunroof frame -2-
-arrow b-.
Note
Do not twist and bend the guide rails and the mounting carrier because there is no brace installed in the front
area.
Installing
– Install the guide rails -1- parallel in the sunroof frame -2-
-arrow a-.
– Guide the rear guide rail -1- on the sunroof frame -arrow b-.
– Install all bolts -2- and tighten lightly.
– Align the guide rails -1- according to the markings -4-.
– Tighten the screws -2-.
Install in reverse order of removal.
Tightening Specifications
1.11.2
Slotted Guide Rail Guide, Removing
and Installing, Sedan from 03/2015
Special tools and workshop equipment required
♦ Torque Wrench 1783 - 2-10Nm - VAG1783-
Caution
A visual inspection when the sliding sunroof is open on the
vehicle is essential to order the correct replacement part. Refer
Note
♦
The guide rails and the mounting carrier form one unit.
♦
The cables and the tilting mechanism are integrated in this component and cannot be replaced individually.
Removing
– Remove the glass panel. Refer to
⇒ “1.6 Glass Panel, Removing and Installing”, page 223
– Remove the headliner. Refer to ⇒ Body Interior; Rep. Gr. 70 ;
Roof Trim Panels; Headliner, Removing and Installing .
– Loosen the connector in the area of the front interior lamp and
loosen the wiring harness -2- on the side of the slotted guide
rail guide -1-.
– Remove the bolts -arrows-.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст