Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 278
– Remove the seal -5- from the assembly frame.
– Only loosen both front left and right screws -4- for the front
glass panel -2-.
– Adjust the front glass panel -3- according to the dimensions.
Refer to
– Tighten the left and right screws -4-.
– Install the trim. Refer to
⇒ “1.6.4 Glass Panel, Removing and Installing, Wagon”, page
.
– Install the seal -5- on the frame.
Tightening Specifications
1.9
Rear Glass Panel, Adjusting
Note
The arrow points in the direction of travel.
– Pull off the inner seal -5-.
– Loosen the bolts -4- from the rear glass panel -3-.
– Adjust the rear glass panel -3- according to the dimensions.
– Tighten the left and right screws -4-.
– Install the seal -5- on the frame.
Tightening Specifications
1.10
Height Adjustment, Checking
Note
♦
The front glass panel is only adjusted at the front edge and the rear glass panel only at the rear edge.
♦
To achieve the best possible external appearance, make sure that the adjustment on the left and right sides
is performed evenly (symmetrically).
♦
The arrow points in the direction of travel.
Height Adjustment, Checking
– Use a depth gauge to check the adjustment of the front glass
panel -1- and the rear sunroof panel -2-.
If the measured values deviate from the specified values, then the
glass sunroof panel must be adjusted accordingly.
1.11
Slotted Guide Rail Guide, Removing
and Installing
⇒ “1.11.1 Slotted Guide Rail Guide, Removing and Installing, Se‐
dan through 02/2015”, page 246
⇒ “1.11.2 Slotted Guide Rail Guide, Removing and Installing, Se‐
1.11.1
Slotted Guide Rail Guide, Removing
and Installing, Sedan through 02/2015
Special tools and workshop equipment required
♦ Torque Wrench 1783 - 2-10Nm - VAG1783-
Caution
A visual inspection when the sliding sunroof is open on the
vehicle is essential to order the correct replacement part. Refer
⇒ “1.1 Characteristics - Sliding Sunroof, Sedan”, page 193
Note
♦
The guide rails and the mounting carrier form one unit.
♦
The cables and the tilting mechanism are integrated in this component and cannot be replaced individually.
Removing
– Remove the headliner. Refer to ⇒ Body Interior; Rep. Gr. 70 ;
Roof Trim Panels; Headliner, Removing and Installing .
– Remove the glass panel. Refer to
⇒ “1.6 Glass Panel, Removing and Installing”, page 223
– Mark the position -4- of the guide rails -1- on the sunroof frame
-3-.
– Remove the screws -2-.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст